Question about Fishing Boats

Open Question

Change outboard motor from manual to electric start

What parts will I need ( part Nos) ?
Can I use earlier model yamaha second/hand parts? If so,what earlier
models? And would the s/h earlier model parts have the same part Nos
as the 2007 motor?
I can procure an after market starter motor,solenoid and wiring. It`s the ring-gear assembly I`m most concerned about.
Can anyone help?
Thanks.
The outboard motor I want to change is a :
2007 model 30 HP Yamaha 2 cylinder 2 stroke Model : 30HMH

Posted by on

6 Suggested Answers

mcgyver468
  • 710 Answers

SOURCE: 40hp 1987 yamaha outboard motor will run for 30-60

Sound like the fuel pump is not keeping up with the engine's demand. Check it out. Good luck. Hope this helps.

Posted on Apr 27, 2009

Editor925
  • 285 Answers

SOURCE: Missing operators manual for Evinrude 2 hp outboard motor

Your best bet is ebay for a replacement user manual. Take a look around, you will come across one... For the meantime, gas oil ratio should be 50 parts gas to 1 part oil, i.e. 50:1. General care: Dont go full throttle for any length of time. Cruise of 3/4 throttle... Always flush engine after use in saltwater, including washing down exterior. Keep spark plugs in good order and check prop for fishing line wrapped around in near the prop hub. Otherwise, get a yearly service and have them check the water pump and replace as needed, get it tuned etc and gearbox oil changed.

Posted on Jun 20, 2009

  • 77 Answers

SOURCE: Looking for a starter solenoid wiring diagram

save yourself some money and go get a lawn mower solenoid and find a way to mount it yourself. I have done a johnson outboard and a tigershark jet ski this way with no problems.

Posted on Jun 21, 2009

  • 1 Answer

SOURCE: year model of yamaha outboard and fuel mix ratio

See linked manual!
JD
Manual

Posted on Sep 26, 2009

  • 86 Answers

SOURCE: Spark plug gap 150 hp Yamaha outboard

The correct gap is .035

Posted on Oct 16, 2009

  • 53 Answers

SOURCE: yamaha 115 will not shut off with key or kill switch

not enough information on the motor. what year and model? but all yamaha outboards are shut down by the C.D.I. being grounded by the key switch or the emergency kill switch. the cheapest thing to test or replace is the key switch and the emergency kill. with more info on engine I can help you further.

Posted on Nov 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to find a lower unit for a 30hp 2 stoke 3 Cylinder yamaha boat motor 501 2841100 casey


30hp 2 stoke 3 Cylinder yamaha Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."


Yamaha Complete Outboard Lower Units

Kijiji Canada

Automotive Parts Accessories Boat Parts Outboard Engines Components...

Mar 24, 2016 | Fishing Boats

1 Answer

How can I get a owners manual for an outboard motot model f15elhg yamaha


http://www.yamaha-motor.com/assets/service/manuals/1/lit-18626-06-72_1374.pdf

Usually all the manufacturers will have their manuals online. Try the link above. If not correct one go to www.yamaha-motor.com and search your specific model.

Dec 27, 2014 | Fishing Boats

1 Answer

My 30 year old Yamaha 75 HP outboard motor won't start despite new plugs, clean fuel and a fully charged battery. Why is this so?


Spare plug, remove spark plug cap and insert spare plug in cap. Place on metal part engine and swing engine, you are looking for a spark at plug . Do not hold plug, if electrics fine it will give you a nasty kick whispichbyou will remember. If no spark then electrics need investigating.

Oct 10, 2014 | Fishing Boats

1 Answer

What type of petrol is needed for a yamaha outboard motor horsepower 8?


reg unleaded gas.

You haven't specified as to its year of manufacture, so if its older, as in a 2 stroke, it'll be a mix of gas and outboard oil.

If its a newer model, a 4 stroke, it'll be injected(Gas and oil seperate)

If you are totally unsure, Consult your owners manual and if you have none, then any Yamaha dealer can use the serial # off the motor to establish any specs on it for you.

Happy boating.

Oct 04, 2009 | Fishing Boats

1 Answer

Yamaha 115 will not shut off with key or kill switch


not enough information on the motor. what year and model? but all yamaha outboards are shut down by the C.D.I. being grounded by the key switch or the emergency kill switch. the cheapest thing to test or replace is the key switch and the emergency kill. with more info on engine I can help you further.

Sep 23, 2009 | Light Outboard Motor Boat Bass Fishing...

1 Answer

2001 yamaha 175 hpdi wont charge above 12.4v at high rpm. only 11.8 at idle. all connections to batteries are clean and tight, both batteries are good only some what discharged at this point from the lack...


You have two components for the charging systems. Stator and Rectifier regulator. As a rule of thumb we always change both. First you need to confirm that the outboard is not charging your batteries. use a battery load tester on your batteries confirm you have no dead cells. Second with a fully charged battery, multi-meter, and a water hose connected to your outboard cooling system. third for a picture and diagram of the ignition system go to www.yamaha-motor.com. click on outboard motors,parts and service, view parts catalog. find your year make and model by following steps listed at top. search electrical 1,2,3 until you find a RECTIFIER & REGULATOR ASSY. Click on generator to find the stator. when you find it you will have a picture reference. Check for good ground at the Rect/reg. the stator creates AC voltage the rect/reg converts to DC. rect/reg conects to the battery to charge it through a solenoid on the engine. Connect your multimeter to this solenoid to get the true reading from charging system. start engine check voltage through all rpm ranges. 13.5 v thru 15 v. The other troubleshooting test and disasembly will require a Manual. also to remove the stator you'll have to remove the flywheel.Clymer Service manuals are available through your local outboard dealer. good luck

Sep 22, 2009 | Fishing Boats

3 Answers

40hp 1987 yamaha outboard motor will run for 30-60


Sound like the fuel pump is not keeping up with the engine's demand. Check it out. Good luck. Hope this helps.

Apr 27, 2009 | Fishing Boats

Not finding what you are looking for?
Fishing Boats Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fishing Boats Experts

ray gallant

Level 3 Expert

36432 Answers

Fordexpert

Level 3 Expert

5331 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Are you a Fishing Boat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...