Question about Sony FD Trinitron WEGA KV-32HS500 32" TV

1 Answer

Sony KV32H5500 stays on stand-by

My Sony KV32H5500 continues to blink on Stand-by but doesn't come on. Any ideas?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Most probably the IC504 (Sharp PQ05RD21) on A-Board went bad. This model TV, including mine, is notorious for having this problem. The IC is rather easy to find and inexpensive (around $2.50). Your main problem will be desoldering the old one and soldering the new one.

Good Luck.

Posted on Jan 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony tv model KV-HA21M80 is having problem front stand by L.E.D is blinking 4 times and stopping


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. Electro help

Jan 14, 2015 | Sony Standard (CRT) Televisions

2 Answers

I have a sony tv model kv-27v42 i have sound but no pictture and stand by light blinks what is the problem


How many times do this standby light blinks at a time of switch on? These blinks are fault indications. From the number of these blinks, you can get an idea about the faulty circuit section inside it. Count it. If you wish to get more details about the blinking codes to Sony TVs, check this link.

Feb 24, 2013 | Standard (CRT) Televisions

2 Answers

Red stand by light blinking continuously black screen


It cannot be reset fully unless it comes on and stays on (the model you have listed here.)

That set should have a blink error code--watch the red power light to see if blinking in a number sequence like 7blinks pause and repeats over and over.

Dec 20, 2012 | Sony KV-36XBR250 TV

1 Answer

Sony tv will not turn on stand by timer light blinking


Try as suggested to count the blinks to see if it is an error code or not. blinks will be in a sequence with a pause and blink the same number of times over and over.

Apr 29, 2012 | Standard (CRT) Televisions

1 Answer

Hello, My elderly Mom has a Trinitron KV-32S10 tv and the stand-by light is continuously blinking and there is no picture, but there is sound. I have unplugged the tv and waited 2 minutes and plugged back...


The blinking light is the fault code to enable the engineer to have a good guess at where the fault area lies.
Count the blinks and tell a Sony repair shop, they will have a good idea of the cost.
Hope that helps.

Mar 02, 2011 | Sony KV-32XBR250 TV

1 Answer

Stand by Light flashing; no pic no sound


had same problem - How old is TV? Sony authorized repair will only address certain sets that are less than 5 yrs, I think. Basically though sometimes only needs adjustment, sometimes new mainboard depending on the humber of blinks that are repeating. Count the # of blinks in a cycle then look up "sony blink codes" for a general idea of what it might be. You may also get some good expert advice if you video tape the blinking and post it along with your model #. Some have found that bad or leaky/bulging capacitors are the culprit, while others have needed replacement IC's, sometimes it is the CRT going bad if it has had long hours and can be fixed by turning up the focus screw inside just a hair to eke a little more life out of it (This is often prefaced by longer warmup and sound but no picture or blanking intermittently). Almost all answers I have found though end up pointing to call a repairman... There is an angry petition thread of hundreds of po'd folks out there too if you wanna sign... I did. And my next tv will be a Samsung....

Oct 23, 2009 | Sony Standard (CRT) Televisions

1 Answer

Stand By timer light continues to blink on Sony Triniton TV


That problem comes up when one or both of the convergence IC's are burnt ... it normally has an "STK" number on it screwed onto some large aluminium heatsink ..... however if you venture to change it get back to me ... I'll try to guide you through ....

May 23, 2009 | Sony FD Trinitron WEGA KV-34HS420 34" TV

1 Answer

The screen stays black when the power is turned on. the stand by/timer ligt blinks


There is a high voltage, and or scan failure. This can be the flyback assembly, and or other support components. If the CRT is defective, it can cause this type of shut-down.

The cost for servicing this would be fairly expensive. It would be best to start shopping for a new set.

Jerry G.

Oct 17, 2008 | Sony FD Trinitron WEGA KV-20FS120 20" TV

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-32HS500 32" TV Logo

Related Topics:

360 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68352 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Are you a Sony Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...