How to descale machine talea giro plus

Perhaps the owner's manual will help? Here's one to download:

SAECO TALEA GIRO Operation And Maintenance Manual

Did you go through the rinse cycle? Check pages 27-29 of the manual...you can see a copy here. http://download.p4c.philips.com/files/1/10002770/10002770_dfu_eng.pdf

For ri9754/01 , 21 , 47

Try holding the descaling button for 6-7 seconds (not 3 as the instructions say) until it stops flashing.

I was told by tech that if you hold the water button in for a few seconds then this resets. It depends on what kind of water you use too. If you use filtered or spring water then you don't need to descale it as often and you can override this by above method. Hope that helps.

Hey, hope these instructions help. thanks for using fixya.

Did you often use the espresso machine for family or for business, when you often use the machine and you used water that is not filtered, you can assure it need to descale often.
Read carefully the manual and follow instruction. Did you descale it in the right amount of solution, how long and its duration?
If still persist ( the descaling light continue flashing ) then it has a defect in sensor. Since your machine is new, its under warranty. Call the dealer where you brought that and a service technician will send.
I hope I give you answer and solution idea for your unit problem.

Try doing another rinse cycle until water tank empties. I had to do that a couple of times, then the red exclamation mark came on. Then I turned knob to off position, refilled water tank, pressed the descale button for 6 seconds, green light came back on and it did its priming.

Keep pressing the water button for 6 secs until the flashing light goes off.

try and hold down the steamer button for 10 seconds, that should reset the descale warning lamp.
Hope that works for you. Andrew