Green and red separation, shadow effect

The tv 100% have convergence problems,it dead.Tv have colors lines R,G,B mis alignments,have colors shadows pictures or 3D pictures look alike?The tv have a dead convergence board,the 2 STK convergence ICS and some or all of it resistors are dead too.These parts on the tv convergence board,must be change to fix the tv convergence board to solved the tv picture convergence problems.The shop,will cost u like $300-350 for parts and labors.

The projection IC's are bad. You can't do this yourself and would probably cost $300 - $400 for a tech to do it. Start shopping.

Nowadays CRT's do not have good quality shadow masks anymore. After heating up a little they can give a so called "blooming" effect giving a blue an yellow leaf effect large over the screen. Reason nonparallelity in deformation of the shadow mask.

that sounds like a typical Convergence IC problem..

http://i.ehow.com/images/GlobalPhoto/Articles/4575598/ConvergenceICs_Full.jpg

this is a picture of what typical convergence ics look like

Go to Menu then setup look for convergence if you do not see convergence on menu then you have a open FUSE FL231 it is on right side of FBT flyback transfomer there is 3 of them small brown rectrangler looking caps it will be the one in the Middle.

Replace the two STK392-120 Convergence Ics you can get replacements at the following link with step by step instructions on how to do the repair.
http://servicemanuals.vstore.ca/

I had this problem with my rear projection screen tv. It was the gel going out in the projection lights. You will need to get it replaced.

Symptoms shows TV has problem of faliure of convergence out ICs. (2 ICs in TV) and need to be replaced.Let me know do you want to repair it at your own? ...
... if yes, it is necessary to have experience of TV repair and basic electronics knowledge.

Good Day;

Sounds like you have bad Convergence Output IC > 267P155010 > STK393-110, replace and it will correct the problem TV uses only ONE, make sure all resistors look good in the circuit around IC.
Good Luck, big IRISH.

it is due to degaussing circuit. it has developed due to changing the side or turning tv or any thing is lying near tv which has got magnetic effect. solution 1 put of tv for 15 minutes 2 do not change direction while watching tv . 3 remove magnetic thing like speaker if is near tv. still if you donot get the result call tech.to degauss it with degaussing coil. it is 2 minutes job. good luck.