Question about Kenmore 16622 Mechanical Sewing Machine
Does anyone know where I may find a manual for the Kenmore 25th anniversary model 13410 sewing maching?
I would like to know how to adjust the tentions and change the sew pattern.
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: thread a kenmore 158 13410????
Not sure if I am too late, but it's pretty basic. I have the same machine...
You have the thread on the spool with the thread on the left side (unrolling off the spool counterclockwise) and put it around the round thing on the front middle (looks like a snap sort of) and through the eye almost right in front of it (the loop) and hold the thread lightly then wrap the thread around the tensioner (the thing with the dial) to the left (counterclockwise) until the springs "pops" it into place. Then run the thread through the little hook thing (by entering from the left) then up to the eye (hole) that is in the little arms that raises and lowers (you might need to spin the wheel to get the arm in the right position) then you run the thread back through the hook thing (entering from the left) around the little half circle thing (by entering from the left) and finally in the hole in the needle...
hope it made sense, I tried to use laymen terms...
Posted on Jul 09, 2008
You can get a manual at www.ifixmachines.com or you could try www.brother.com. Best bet is the general manual order form, I'd pay with paypal.com and they'll get you the manual or refund your money.
Good luck, that seems to be a older model
Posted on Jan 16, 2009
You put the hook (the half moon thing with a sharp point on it) in the machine by placing it opposite the little curved bar. Make sure it is seated properly on the ridge. The you take the race, the circular part with a small plate on the top and place that over the hook(the plate side will be facing up). It will only fit a certain way, it could have a slot that a notch fits into (that is usually how it goes). Then slide the arms over it and they will snap into place. Once done, turn the handwheel and make sure everything moves smoothly. If not, you'll need to start over as something isn't seated correctly. Then you can install the bobbin case as usual.
Posted on Mar 01, 2009
Sounds like you may have a blockage somewhere in the bobbin area that needs cleaning as this is normally what happens when it gets jammed. Reverse sewing can sometimes cause jams. Remove bobbin area and reassemble.
Posted on Jun 11, 2009
Tips for a great answer:
Mar 11, 2017 | Brother Sewing Machines
Sep 06, 2016 | Kenmore Sewing Machines
Jan 20, 2016 | Sewing Machines
Nov 24, 2010 | Kenmore Sewing Machines
Mar 09, 2010 | Sewing Machines
Jun 23, 2009 | Kenmore 744-08BH Mechanical Sewing Machine
Jun 19, 2009 | Kenmore Drop-In Bobbin 505S-21BH...
Aug 15, 2008 | Sewing Machines
Mar 21, 2008 | Kenmore 16622 Mechanical Sewing Machine
Aug 19, 2009 | Kenmore 16622 Mechanical Sewing Machine
71 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: