An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: cant register my black and decker tools onlne
Changes were made to the website. Start at blackanddecker.com and select the customer support option that appears at the top right of the page. You will see the option to register your products on the left under heading of products and services. Click on product registration. Sign in as a guest and you should be able to register your products. You also have the option of signing up a a member.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The model that I looked at on the internet has a high temperature switch that will not let the compressor run if it gets hot (about 15 minutes of operation).
It will cool down in 10 minutes and allow the compressor to run again.
This MAY be the problem.
Could be leak or faulty valve plate in head. Use soapy water and spray all fittings including drain valve and pressure regulator. Repair as needed. If no leak found suspect problem with compressor. Try simple test, with compressor running and has reached max pressure (60psi) remove air filter and feel intake for suction. Be carefull could be hot. The suction should fairly strong. If no suction or actually feels like air is blowing out of intake, suspect valve plate. Parts are available at dewalt service center or www.toolpartsdirect.com. Good luck
Hi, I suspect the plunger for the valve stem connector on the pressure head is not depressing the air release pin in the head of the valve stem.
I have a Black and Decker and have to use a valve stem seat removal tool to quicky unscrew about 3 to 4 turns the stem seal and then connect the air hose head. After the tire reaches the correct air pressure I have go thru the tighten the valve stem seat drill.
You can buy the vavle stem seat tool at any auto parts store. I keep mine with the compressor.
I don't want this to sound bad but... is the air hose supply vavle turned on? Some have a slider button on the valve you have to push to charge the hose. If the hose is charged then see above.
I hope you are asking about the Black and Decker Bright Bar. You request was posted under the "air compressor" category. Please comment on my solution so I will know it was helpful. Here is a link to the black and decker home page. Click on the grey bar in top right of the page to register your Bright Bar.
Changes were made to the website. Start at blackanddecker.com and select the customer support option that appears at the top right of the page. You will see the option to register your products on the left under heading of products and services. Click on the product registration option. Sign in as a guest and you should be able to register your products. You also have the option of signing up a a member.