Question about Kenmore Elite HE4 Electric Dryer

1 Answer

Kenmore dryer smartheat quietpak 9 lights on for timer wont start

Wont start and beeps. I found a bulb busted and burnt out in drum. ZI have unpluged over night to reset computer, what now?

Posted by on

  • Anonymous Mar 22, 2014

    have checked all lent traps,left unplugged all night and moved the timer dail still wont start is there a reset button?

  • Anonymous Mar 30, 2014

    I've unplugged and manually opened drum, when I start it again it does the same thing

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check the door switch

Posted on Dec 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

QuietPak 9 Dryer not working...


contact a dentist they have some amazing glues that they use for holding crowns on to jaws. I have a crown held on with this type of glue and it is incredibly strong.
http://www.kerrdental.com/kerrdental-cements-2

Oct 20, 2014 | Dryers

1 Answer

My dryer is displaying F70, and will not work, other than drum light. The dryer is a kenmore smartheat quietpak 9 model 11087081601


The F70 error indicates a heartbeat failure of the central control.

If the error occurs while the washer is running then likely it is a problem with the interface. If the error occurs while nothing is running then the central control is most likely at fault.

If the error occurs while the motor is running then the console/membrane is most likely at fault.

This problem can be caused by a short in the low voltage circuit.

It is a difficult problem to pin down and the parts are to expensive just to replace so I suggest a technician check and repair this problem.

Jan 01, 2011 | Kenmore Dryers

1 Answer

Kenmore Elite Smartheat Quietpak 9 Dryer won't turn on.....as if there is no power. After being unplugged for a while, it will run one cycle.


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Nov 22, 2010 | Kenmore Elite Oasis 6808 Electric Dryer

2 Answers

Kenmore Elite Smartheat Quiet Pak 9 won't start. Light turns on and off inside drum when door opens/closes, but no lights come on on the outside display.


My Kenmore Elite dryer keeps beeping..just going through the end of cycle alarm-high,low,off...anyone have any suggestions?

May 30, 2010 | Kenmore Elite HE4 Electric Dryer

1 Answer

I was given for free a kenmore he4 smartheat quietpak 9 dryer from a friend that was moving overseas. I have owned it for 1 week and all of a sudden it will not turn on. All the lights come on (red) and...


Have you tried unplugging the power cord yet? Leave it off for 2 minutes. It may reset the unit and solve your problem. If not, let us know and an expert from this category will try to help you further.

May 17, 2010 | Kenmore Elite HE4 Electric Dryer

1 Answer

My Kenmore Elite Smartheat Quietpak 4 will not start. F70 code


leave door open and press the rubber botton inside, \ I just hooked up mine and it did same thing, i pushed botton light went out, so this told me the door wasnt closing correctly, you have to push hard on door first couple times. hope this helps you.
dave

Feb 09, 2010 | Kenmore Elite HE4 Electric Dryer

1 Answer

I have a kenmore elite smartheat quietpak 9 model#110.85872401, it will not heat up just cold air. the air lint filter is clean.


make sure it is not set on air only,just went to a job and that's what it was lol.unplug dryer,take off bottom panel,on right side you'll see the heating element,pull off one of the wires and read out heater with a meter,if it's bad you'll need part number 3387747

Nov 07, 2009 | Kenmore Elite HE4 Electric Dryer

2 Answers

Control locked


Mine has an "auto dry" button. It says underneath, "Press & hold 3 seconds..." to unlock control. I did it, it worked.

Feb 07, 2009 | Kenmore Elite HE4 Electric Dryer

Not finding what you are looking for?
Kenmore Elite HE4 Electric Dryer Logo

Related Topics:

746 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you a Kenmore Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...