An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 500 times.
Re: Only One Direction.........
It appears that your mouse has a cord and small ball on the bottom. If so what you need to do periodically is take the cover off the bottom of the mouse and with a Q-Tip clean the rollers inside the mouse and remove the dirt, Usually is the problem. Hope this helps. Bud
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
remove the ball ring take the ball out and visually check to see it alot of link has accumulated on the rubber wheel surface, if it has gently use a pair of tweezers or a q-tip w/alcohol to clean the surface of the directional wheels.
Is this a USB or PS2 mouse? Have you tried a different mouse already. More than likely this is a bad mouse. If it has a ball in it and is not optical, try removing the ball and cleaning out the inside. If this doesn't work, replace the mouse.
open the mouse
remove the ball
you should see two support shaft for the ball
check whether they are rotating
clean them if you can
if they rubber shield of shaft is damaged try replacing them with valve tube you usually use in a bycycle tyre
clean the transistors standing near the shaft flywheel using a soft cloth
it will be fine
Q: After pairing my mouse, the button click works but cursor tracking does not move. What can I do?A: The cursor tracking problem is because red sensor LED is not on. Please try another set of battery or fully charge battery again, and verify if bottom red LED turns on. If red LED still does not turn on, please remove batteries from mouse, press and hold the pairing button for 5 seconds, next press and hold the left and right buttons simultaneously for 10 seconds, followed by several clicks. Install the battery into mouse, you should see red LED turns on, mouse cursor will move.