Plasma TV will not turn on

Faulty or worn internal surge protector. External surge protection recommend.

I don't know

Sounds like a panel fault. Contact the authorized service center for Panasonic. Gopakumar Gopalan Google

Switch off TV, switch off power, remove plug and wait for 48 hours and retry.
If problem persists, I suggest it is better to refer it to a qualified service
technician, since the back cover has to be opened for investigation/rectification.

I unpluged mine and the light was still blinking when it was unpluged. I thought that was weird. So I pluged it back in and just heald the power button in untill the light went out. It went out within ten seconds. I pushed the power button again and the tv went on. WOOHOO!!! Just needed reset, I guess.

I would use the warranty at Bestbuy at that point. Opening up the TV would most likely void the warranty.

Here's the number to HP case management 877-917-4380 ext.79, try this number and be firm that they need to fix this, I just had an HP plasma that was 3 yrs old replaced for free, no charge. Good luck

The first thing is to take out the batteries from the remote when the problem acts up. If this fixes it, replace the remote. If not, go to the front of the tv and find all the buttons that are on the tv. Start by pushing all of the buttons one at a time. They should all feel the same and sound the same when you push them. If one of them does not, then the buttons are the problem. If they are good, take to a repair shop. The main control board is bad.

well did you do that and did it work ? i guess that panasonic doesn't say that for nothing so try that first , and unlike lcd tft tv's plasma need to be warm to get the best picture

did the tv get bumped or ran into it sounds like the plasma tube is broken but i need more information to be sure, you could have a power problem or a remote problem try unplugging it for 5 minutes to reset it, then hold the power button down for 5 seconds and see if it comes on if not give me as much more info as possible.