JVC KD-AVX2 new installation will not power up

Probably red but need to know what amp model etc and you might also Google this question

have you installed the speaker right... front left + & -..... etc

if you look where the cd goes on the sides there is like little guides push them to the side and it should take cds then

i got audio no video

there is no power on the red wire of the unit when you turn the key to acc on your car. check all the fuses on your car

check the wires in the back of the stereo if not then make sure the back speakers are not hooked up to a internal amp and if it is make sure that it is not blown

I'm not sure after reading owners manual...page 59 refers to writable/rewritable disks have to be finalized to play. Here's a link to your JVC KD-AVX2 manuals.
http://resources.jvc.com/Resources/00/00/93/LVT1454-001B.pdf

Hello jlj2382,

Here's the wire colors for your KD-AR560:

Black = Ground (to vehicle chassis)
Yellow = Constant 12V (power)
Red = Accessory (to vehicle accessory terminal)
Blue/White = Remote turn-on lead (to remote amp)
Orange/White = Illumination (to vehicle light control switch)
Brown = Cell Phone terminal
White = Left Front Speaker positive (+)
White/Black = Left Front Speaker negative (-)
Gray = Right Front Speaker positive (+)
Gray/Black = Right Front Speaker negative (-)
Green = Left Rear Speaker positive (+)
Green/Black = Left Rear Speaker negative (-)
Violet = Right Rear Speaker positive (+)
Violet/Black = Right Rear Speaker negative (-)

Hope this helps.

Yes, You will need an Amp for this Settup. Check the Rated Power of the Subwoofer and Get an Amp that will Supply this amount of Power. Please Rate My Response! Thanks!

hi. if you have standard slot for head unit this stereo will fit with any problems.jvc just look like a biger but is not.the frames all smool.sorry my language is poor!have a nice sound