Question about PC Desktops

1 Answer

I have a ACER AL1711 flat screen that turns on then after a few seconds it goes blank

Posted by on

  • juno69 Dec 20, 2008

    Thanks for that DrWarpo, my mate will be coming around later today to solder them ,as he is better at soldering than I , and again thank you , juno69

  • juno69 Dec 22, 2008

    Hi DrWarpo, how would I fix that , thanks juno69


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 111 Answers

It is probaly the coils in the flat panel resolder them and that will fix them if you do not know how write back and I will give you instructions

Posted on Dec 19, 2008

  • Leslie Dec 20, 2008

    you are welcome


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Screen goes blank

Here are the Few steps which you can do by yourself to bring back the display(if your Luck is GOOD:D )

Open the Case and check if RAM is properly fix.. just take out the RAM, Clean it and fix it back properly.

search for CMOS battery on the motherboard.. just remove it for 10-20 seconds and fix it back.

Remove the CPU Fan and CPU and Fix it properly.

It happen when you shift your PC from one place to other.
ALL the best and if it works than please give ranking.

Aug 02, 2012 | Acer Veriton 5800 PC Desktop

1 Answer

When I switch my laptop on and it gets to the log in screen, after I type my password and click log in the screen goes blank for a few seconds then a white screen pops up saying navigation to the webpage...

Click Start/Control Panel and look for Display or Appearance and Personalization. You can also just Right Click on an empty space on your desktop and select Properties. When the Display appears, click the Desktop tab and select a background.

May 18, 2012 | Acer PC Desktops

1 Answer

Touch screen on acer z290 goes blank after 2 seconds

mine after few second turns off.
cpu remains cod and fan is working and nothing getting hot on matherboard.

Feb 23, 2012 | Acer Veriton Z290G 185 320GB

1 Answer

I just bought and hooked up an Acer Widescreen 23'' monitor. When I start it, because I turned off the computer at the switch, it starts up with the ''windows is checking your disk'' etc. It completes the...

when you turn off the computer with the switch, you are bypassing the correct shut down procedures for your operationg system. Use the start button, select turn off computer and see if this problem doesn't magically go away.

May 03, 2010 | PC Desktops

1 Answer

My srceen goes Blank


first try booting the laptop and pressing the Fn key with the numerical ( numbered key ) that has a picture of 2 screens on it. This is for booting to an external monitor. you could also try adding an external ( pc monitor ) this will eliminate any motherboard Faults.

Secondly, the graphics chip driver may be corrupt or not installed correctly. if you have a restore cd, you could try booting the laptop, with the cd in the drive.

you can then try, to see if the settings in the bios are all correct, by booting/starting the laptop and pressing esc or F2 or delete immediately as the laptop starts. ** Be-Careful** what you adjust.
My suggestion is to look for. ** default settings tab** or load setup defaults.

these are the obvious things to try, before assuming that you have a faulty graphics chip or motherboard fault.

Mike @ compurepair.

Jun 12, 2009 | Acer PC Desktops

1 Answer

19" Topsync CRT display is flickering

the motiter to pc cable is problem yaar you change it the problem is solved

Dec 06, 2008 | ZT Group CISNET A7050 PC Desktop

1 Answer

KDS monitor screen goes blank.when you shut it off & turn it back on it goes blank again within a few seconds.

make sure all the cables are secure... by unplugging and re-plugging them back in. Does the monitor feel very hot in the back or on top? If so unplug the monitor and tip it upside down to make sure nothing metal fell inside.

Apr 30, 2008 | PC Desktops

Not finding what you are looking for?
PC Desktops Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top PC Desktops Experts


Level 3 Expert

5660 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18299 Answers

Are you a PC Desktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides