It felt to my wife today and the knob came out (plus some plastic parts broke inside) I have put the knob back in position but when I switched on there was a small flash on the top part + plus a bad smell and now it's dead: I tried to open to look for a possible fuse but could not reach the motor from below. Sorry for my English.
Hi, do you still have the broken k3000?
I am interested to spare parts.
Where do you live?
Hi Federico
Hi Federico - The K3000 has been repaired.
Hi toni, did you found the service manual? i did italian meringue, and the plastic gear just melted :$
×
SOURCE: My Braun MR5500BC Multiquick professional
I have a Braun Vario Model 418 hand processor - motor works fine but when attached to the blender, the blender shaft vibrates - if you look into the inside of the blender, the shaft is shaking - may be some support is missing. Can any one advise what can be done.
Jaya
[email protected]
399 views
Usually answered in minutes!
Does anyone now where to find the service manual for this Braun Multiquick 7 K3000? I'd like to check the motor but I couldn't reach it by simply opening the bottom of the device and con't open the top part (where the switch knob is).
Hi toni, did you found the service manual? i did italian meringue, and the plastic gear just melted :$
Hi toni, did you found the service manual? i did italian meringue, and the plastic gear just melted :$
×