Question about Sony VPL CS6 Multimedia Projector

Open Question

Sony VPL-CS6 taking forever to come on after power outage.

Ok, so we live in Zimbabwe where power outages are a daily occurance. We have a sony VPL-CS6, and after we get our power back the projector light takes forever to come on. And we can only switch it on when the light comes on. So we have to wait and wait. Sometimes longer than other's. The one time it took several hours to come on. We've cleaned the air filter and fans. Not sure why it taking so long. Do we need a voltage regulator?
Please help...

Posted by on

3 Suggested Answers

projdoc
  • 2236 Answers

SOURCE: my projector sony vpl cs6 projects yellow

reset the settings to factory default and change your cable. if that doesn't help, the polarizer filter on the blue lcd panel is fried due to excessive dust and heat. the optical engine will need to be replaced.

Posted on Dec 08, 2009

Testimonial: "Thanks very much for the help. "

heathgr
  • 442 Answers

SOURCE: vpl-cs6 projector problem

What's the problem

Posted on May 29, 2011

  • 1 Answer

SOURCE: My Sony Data Projector VPL CS6 is stuck in

I tried the emergency mode and recovered the powered mode. just make sure you can turn the adjuster ( that big grey plastic screw) freely and leave it that way (don't tighten it or put the **** back in). try turning it on. works for me..

Posted on Jun 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Projector vpl cx21 cust the edges of the image


In the menus there should be an "image" adjustment option, it could also be related to the "sync" rate. Try different settings. You may also need to adjust the resolution you're sending to the projector from your computer.

Oct 08, 2013 | Sony VPL CS6 Multimedia Projector

1 Answer

Sony Vpl -cs6 Lamp hour reset Procidure.


Connect the power cord and turn on the projector.
When it's in standby mode, press the following keys on the remote in this order for less than 5 seconds each.
RESET
left arrow
right arrow
enter

Aug 20, 2011 | Sony VPL CS6 Multimedia Projector

1 Answer

I have Sony VPL CS6 projector and the lens cover stays open and wont shut to cover the lens!! The Lens/Cover light on it flashes? It does project for about 15seconds or so but then goes off, this is when...


It is possible that there can be few reasons for the fault siad:
1.the lamp can be faulty
2. the filter can be clogged.
3. the lens cap trigger switch can be faulty and staying on
4.The power supply can be faulty, not delivering the power but shuts off.
5,the main processor board can be faulty witth errors.
It might need board swapping to confirm.

Sep 25, 2010 | Sony VPL CS6 Multimedia Projector

1 Answer

Manual de sony svga vpl-c57


I have the CD projector but i can

Jun 14, 2010 | Sony VPL CS6 Multimedia Projector

1 Answer

My Sony Data Projector VPL CS6 is stuck in emergency mode, can it be reversed.


I tried the emergency mode and recovered the powered mode. just make sure you can turn the adjuster ( that big grey plastic screw) freely and leave it that way (don't tighten it or put the **** back in). try turning it on. works for me..

Feb 23, 2010 | Sony VPL CS6 Multimedia Projector

1 Answer

My VPL CS6 will not turn on. I tried different cords and power points and the dust and lamp covers are securely closed.


It could be that you have put the projector into emergency mode. If this is the case you can only switch it on by moving the small switch by the leg tilt underneath, and then maually open the lamp cover by turning the adjuster with a coin, see page 48 of the manual for instructions. Hopw this helps

Jan 24, 2010 | Sony VPL CS6 Multimedia Projector

1 Answer

My projector sony vpl cs6 projects yellow


reset the settings to factory default and change your cable. if that doesn't help, the polarizer filter on the blue lcd panel is fried due to excessive dust and heat. the optical engine will need to be replaced.

Dec 07, 2009 | Sony VPL CS6 Multimedia Projector

2 Answers

Sony VPL CS6 in darkness !


Make sure the interlock switch is activated by the cover of the lamp.
Can't measure a voltage with the lamp cover open. High voltage is powering the lamp from an smps or ballast supply. If lamp is New, cover switch is good, then the lamp power supply could be faulty.

Siliconchip.

Dec 29, 2007 | Sony VPL CS6 Multimedia Projector

Not finding what you are looking for?
Sony VPL CS6 Multimedia Projector Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Multimedia Projectors Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

68352 Answers

Are you a Sony Multimedia Projector Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...