Question about Sennheiser RS 110 Consumer Headphones

Open Question

Problem with headset sennheiser TR115

Recently when I have been listening to the television through my headset (sennheisser TR115) wireless, the green light on the bass station go's out & I get an earfull of interfearance.
Now when I unplug the jack plug from the set & then put the jackplug back in,the green light comes on again & the sound is good for about 10 minutes.This has only happened recently,any ideas please.

Posted by on

6 Suggested Answers

  • 2 Answers

SOURCE: Sennheiser RS 130 Wireless Surround Sound Headphones

Did you try to remove the batteries and at the same time unplug the power of the base for 30 sec ?

Posted on Jan 21, 2008

  • 7 Answers

SOURCE: No sound coming through my Sennheiser wireless headphones

Turning the transmitter on and off (Fig. 5)
Turn on the sound source. This automatically activates the
transmitter and the green LED “ON/OFF” lights up. If the sound
source is turned off, the transmitter is automatically deactivated
after approx. 3 minutes (the LED “ON/OFF” goes off).
Note: The automatic level control only functions if the volume of the
sound source is sufficient.

Posted on Apr 02, 2009

  • 61 Answers

SOURCE: Replacement connector for Sennheiser PX 250 doesn't work...

The bare copper conductor wire is the screening/common earth to the two signal wires of green and red. The important connection is the copper wire which goes to the jack plug earth which is the section furthest from the tip. The other two are the left and right signal connections. If you get these the wrong way round you will just have to swap them over. Check if they are the right way round by using the balance control on your amplifier or whatever. Have you checked that the problem is not with the headphone amplifier within your equipment? Don't rely on OK sound from loudspeakers as the headphones may be fed from separate op-amp output chip. Try another pair of cheap and cheerful headphones to make sure.

Posted on Oct 04, 2009

  • 1 Answer

SOURCE: Brand new Sennheiser RS140 headphones stopped working

Mine is a bit older (2yrs), but I have exactly the same problem. Absolutely no sound from the headphones (no beeps). I also tried new batteries, but still nothing.

If you have a solution, let me know!

Tanks

Posted on Dec 17, 2009

  • 4 Answers

SOURCE: Sennheiser Wireless Headphone Stops transmitting signal

Hi,

If you're using a mac, I've made an instructable on how to make this a little more bearable..

http://www.instructables.com/id/Wireless-Headphones-3-minute-transmitter-cut-off-f/

I'm sure there is a way of doing it for a pc using a batch file or something but I'm not too up on my pc programming anymore..

Hope it helps..

Rob.

Posted on Jan 18, 2011

  • 100 Answers

SOURCE: i am attempting to use my sennheiser rs 110

What are you plugging your 2 RCA connectors (from the headphones) into on the television?
You are correct, usually:
White = Left Red = Right

In this case
Black = Left Red = Right
Not sure....guess some manufacturers need to be different...
Back to the issue,
You to need to connect the Black to White and Red to Red to the TV BUT you need to make sure you are connecting to an OUTPUT and not to an INPUT on the TV. Most newer TV's do have an "audio out RCA jacks" on the TV but not all. It should be labeled at the connector if it is an output, or just another input. You can always consult the TV manual to be sure.

Few things you can do to test

  • Does your TV have a "headphone jack", use the adapter (2 RCA female - 3.5mm connector) to plug into the headphone jack and see if there is sound
  • Connect the Black and Red RCAs from the headphones directly to the another output, like a DVD player, CD Player etc....

I hope this helps,
Magoo

Posted on Mar 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I cannot control the volume on the headset...only on the TV. Any thoughts as to what I can do?


You could try taking out the batteries for a minute.

If that's no help then contact Sennheiser customer support:

Jul 23, 2016 | Sennheiser HDR 170 Wireless Headphones

1 Answer

Sennheiser Wireless Headphone picks up unwanted transmissions


This headset uses a 900 MHz frequency for connection from the headset to the base.
You will always incur lots of interference in a busy office using that frequency band. Any antennas on the roof or close by?
Amateur radio users?
The other thing, you might have a faulty power supply or "dirty power" coming into the unit. You can try and isolate in a current regulating power bar and see if that helps.
Else, consider changing technologies and moving to, say a DECT band.
Avoid, 2.4 and 5 GHz bands as they are in the wireless devices range and likely will incur equal amounts of interference.

Jan 08, 2014 | Sennheiser RS 120 Consumer Headphones

1 Answer

Sennheiser RS160


Hello,
I've got the same problem.... the green LED is not flashing on the base unit....Can anyone help us please ? Thanks a lot!!
Arnaud

Feb 08, 2012 | Headphones

2 Answers

The sound keeps breaking up the green light goes out and there is a terrible hissing sound


I know this is a bit late but i had the same issues with my unit. turns out if you listen with the source volume really low the headphones cant detect sound so they shut off. you fix this by simply adding more volume from the source and then just decrease volume on the actual headphones to obtain desired listening level and say goodbye to this issue.

Jan 17, 2011 | Sennheiser RS 110 Consumer Headphones

2 Answers

Complete silence on HDR 130 headset - probably in discharged state for some time, now charged for 48 hours


I had complete silence on an HDR 130 headset (no beeps, nothing), but I solved this problem using a solution posted on another thread. Unplug the base, take out the batteries and wait 30 seconds. Reconnect it all and listen. Mine started working immediately!

Dec 07, 2009 | Sennheiser HDR 130 Consumer Headphones

1 Answer

Sennheisser cx300 ear buds ..one channel has lost volume.


I have been having the same problem for the past week, I have just fixed it, reading your post gave me the idea to clean them and it actually worked

What i did was to "heat them up" with a hair dryer so that any wax from my ear that had gotten inside would "melt", then I cleaned them with alcohol and a q-tip and I made sure I let a bit of alcohol to get inside the ear bud, then I dryed it with the hair dryer again very carefully and tested to see the results and WHALA works just fine

Apr 10, 2009 | Sennheiser CX 300 Consumer Headphones

1 Answer

Sennheiser RS 130 Wireless Surround Sound Headphones


Did you try to remove the batteries and at the same time unplug the power of the base for 30 sec ?

Jan 10, 2008 | Sennheiser HDR 130 Consumer Headphones

1 Answer

Unable to listen to my wireless


They need a minimum level of signal to switch on the transmitter.
Verify if it works on yet another system.
Make sure you have the right output on your Samsung.
Try to increase the output level of your Samsung...(up the volume, but it may be a fixed output..)

Dec 02, 2007 | Sennheiser RS 110 Consumer Headphones

5 Answers

No sound, only static


Hi I had the same problem and just emailed Sennheiser.Go to the menu on your TV and change the variable audio output to fixed. I use the headphones through the home theatre so the volume must be max on the home theatre and then you can adjust your headphone volume. It absolutely worked and I don't get anywhere near the static noise when I go to another room with the headphones on that I got previously. Also be sure your audio cable is plugged into the fixed audio output socket. I did not have to do anything with that.

Oct 18, 2007 | Sennheiser HDR 120 Consumer Headphones

Not finding what you are looking for?
Sennheiser RS 110 Consumer Headphones Logo

Related Topics:

405 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sennheiser Headphones Experts

gbob59

Level 3 Expert

2963 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Brad Brown

Level 3 Expert

13569 Answers

Are you a Sennheiser Headphone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...