My cr125 wont idel after stating can it be ajusted.

There is no ajustment. The belt tensioner takes care of any slack and has a square 3/8 hole for a rachet for belt replacement.This will allow you to take the tension off of the belt for removal.

hi you will need to ajust the sencitivity of the alarm this has happened to me also with a little ajustment it will solve the problem

you will have to ajust the fast Idel down an then for the Idle air an fuel screws up till it Idels even. If it does not Idle even you have went to low on the fast idel. Only adjust the screws a quarter turn at a time till you get it to purrr like a kitten. I also have one of those an had the same problem.Luckily my father is a master mec. for caddys,ford,chevy,dodge,etc.He can pretty much listen to any car made ever imports an fix whatever is wrong. Hes 74 years old an thats all he has ever done is work an build old cars.

It's the idle speed adjustment. Forward (clockwise) for faster/higher idle, back for slower.

on your carb you will find 2 screws 1 is a thritle stop screw the outher is the mixture screw the ajustment y need is the throttle screw hope this helps

if your tic over is to low on your carb there is an ajustment screw connecting to throttle cable giv it a turn untill y are happy

I give this site a go, I found great info on repairs of my Sabre.

http://www.sabmag.org/

I hope this may help,
Tom

Adjust in gear 7. If you try to adjjust in gear 1 you will get it to tight and it wont work properly

Thank u for your prompt reply. I ended up by going to a mechanic the next morning. He must have felt sorry for me and had a quick look at it. Yes it was the timing. everything is going well now thank goodness as we are having a heat wave in our state 43 degrees HOT

ck for bad bearings in a pulley or tensioner/