An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: images doubled and red blue green colors all seperate
Look in menu go to setup see if you have convergence listed on menu if not you have open fuse FL231, located next to flyback on right side there is 3 in aroll small brown looking caps middle one is it FL231.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If it looks like three seperate images one of each color then its a convergence issue and it could be one of three things but if you send a email to firstname.lastname@example.org they will assist for free and help determine exactly whats happening with the TV.
It will depend on the model but, you note which input you have the DVD hooked up to on the rear of the set---Component 1? 2? Then you use the input (some Mitsubishi's label it Device) and move until you are on the same input the DVD player is connected to.
If your DVD is HD you will if not using it for HD reception connect to the DTV input which is input on back---again not knowing the model number of your set--it is this simple---watch on whatever input the DVD player is connected to---most need a component input but some will use RCA which is yellow (video) red and white which are audio.
Component inputs require Green to green, Blue to Blue, and Red to red AND SEPERATE red and white for audio. 5 connections for typical component and three for RCA or composite.
Let me know if this helps you by rating this solution as I do this here for free.
Ur tv convergence are dead.U know how to solders?Must replaced 2 STK convergence ICS,some or all it resistors.Tries websites Tv repair world.com,Tvrepairkits.com to buy a convergence kit to repair it ur self.The shop will cost u $300-350 for parts and labors.
sounds like the sensors are out of focus and your red sensor isnt turning on. look in the back of the tv for a master reset button or in your menu screen some sort of "Flash focus" or "convergence". They will realign the 3 sensors.
The only time I have had issues like this was because of the Component Cables not being in the right position (the Red and Blue connections switched), or a bad Component Cable where the Blue Connection is not receiving a signal. Swap out the cable to be sure and double check that it is properly installed. Green to Green, Red to Red , Blue to Blue.
Hope this helps,
convergence issues. i see this alot at the shop. i first suggest you read the article i wrote on the fl231 problem in my profile under tips and tricks. this might be a simple inexpensive repair. if this dont apply or help let me know and i see what i can do
Your tv is crt-based and is out of convergence. In other words,
the settings for keeping the Red, Green and Blue images aligned have
drifted and must be reset. This is common with CRT projectors and
CRT rear projection tvs.
Refer to your owners manual for instructions on re-aligning it.