I need a manuel for a awoe9140

SD is a suds code. Could be build up in pressure hose for pressure switch or pump can not drain.could be a bad pump. How old is the unit?

http://rent.rugdoctor.com/support contact them,they dont make instruction manuals

REPLACE WATER ALL YOU NEED TO DO IS DRAIN THE COOLANT SYSTEM.REMOVE THE ENGINE COOLING FAN AND CLUTCH THEN THE FAN SHROUD.REMOVE ENGINE COVER IF EQUIPPED.THEN REMOVE THE ACCESSORY DRIVE BELT.UNBOLT THE POWER STEERING PUMP MOVE IT ASIDE DONT DISCONNECT ANY POWER STEERING PUMP HOSES.DISCONNECT WATER PUMP HOSES, REMOVE BELT PULLEY THEN REMOVE WATER PUMP MOUNTING BOLTS AND WATER PUMP.CLEAN WATER PUMP MATING SURFACE BE CAREFUL DONT SCRATCH PUMP SURFACE. BESURE WHEN YOU INSTALL NEW WATER PUMP USE GASKET SEALANT ON BOTH SIDE OF GASKET TO KEEP IT FROM LEAKING COOLANT.

Hi from retired Englishman in SW France,

Sorry, if you cannot find it there is little likelyhood of anyone on the forum being able to because we would only be doing the same thing for you ;-0(
Have you tried the manufacturer's web site direct?

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

manually defrost unit(no hot water) wash out interior with bicarb, dry out.then using a thin wire with a very small piece of cloth dipped in clorine bleach clean out drain/vent from inside to outside.swith unit back on. all is well when operating temp reached.no need to call repairman for this.(this is the first thing they do......anyway)

Haynes manuels - most auto parts stores sell this manuel or the chilton manuel

Go to autozone's website at autozone.com and register your vehicle. It's free and you will have access to a full online repair manual for your vehicle. That takes care of your manual problem somewhat, so let's see if we can figure out the problem. Check to see if any hoses are loose or leaking. Check the water pump to make sure it is not leaking out of the vent or "weep hole". If the water pump is leaking, then it is bad and must be replaced. Sure hope this helped you!

What size is your pool I could let you know how many pounds should be in there.
Most likely it would be easier to test your salt content. You need a 12 dollar test kit that has 10 tests in it. It is very simple just put an inch of pool water in a cup and let the test strip sit in it for about 5-7 minutes. Then read the results. Compare with the bottle #'s if too high then drain some water and add fresh if too low then add salt. ( your ppm should be as close to 3000 as possible) Keep in mind algae is due to lack of chlorine or improper ph and alkalinity not salt content. How often do you run your salt system? at 80degrees I run my salt about 4-6 hours a night and then switch it over too just filtering for 8 or more hours.
Also keep in mind that for a pool to be truely filtered it should be turned over at least 3 times so if you have a 5000 gallon pool and only a 2000gph pump it should filter for 7-8 hours. If you have any specific questions feel free to contact me

99 out of 100 washers tend not to drain water out due to blockage inside either waste water pipe (also called waste hose, drain hose and etc.) or circulation hose (the one between pump and drum). To check this lay the machine down on one of the side walls, remove the back cover (2 or 4 screws), disconnect hoses from the pump and ensure all blockages are cleaned away, all coins, small socks and other stuff is removed. Also you might want to clean the pump itself as at this point you're more than half-way through.
1 out of 100 drain malfunctions appear due to pump motor or the main PWB, but I bet that you won't need to replace neither of those.

Please let me know if there's something more I can help you with

Good luck

does the trigger feel like it is doing anything? if not you may find that your handle lever guard is broke and needs to be replaced. this is the plastic piece at the top of your handle and can be removed by taking out the screw. if this isnt it let me know.