Question about MPC Computers TransPort GX3 Notebook

1 Answer

Power button has sliped agine agine

Dear sir
i am jaleel from dubai,my laptop MPC transport T2200 my problum is main power on/off switch has slip then i rest {by the knife} agine slip agine agine how can solve it
thanks verymuch

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 46 Answers

Hmmmm, well even if the power button has 'slipped' you should still be able to press it with a pencil to turn it on (even taking off the button and just pressing the button Underneath may help).
Sorry if I don't understand, you might have to elaborate.

Posted on Dec 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

MPC wont turn on!


Remove the battery and press down the power button for 10seconds and leave for another 10mins, then install the battery and see.

Jan 29, 2014 | MPC Computers TransPort GX Notebook

1 Answer

Where is the battery located on MPC TRANSPORT T2200.


On the bottom at the back of the laptop.

Nov 06, 2013 | PC Laptops

1 Answer

Reseting mpc t2200 to factory settings


turn the laptop off and then on and watch the screen carefully. It will usually say something like Press F11 (or some other key) for Restore. Press the stated key while you can still see the message.

answer found here: http://uk.answers.yahoo.com/question/index?qid=20080418062022AAq1ycb

Dec 10, 2012 | MPC Computers TransPort T2300 Notebook

2 Answers

My touchpad on my mpc transport t2200 is not working as a mouse


Also if your ac adapter(powercord)is bad, the touchpad/mouse sometimes will malfunction and become impossible to use or not work at all.Start with checking your ac adapter voltage or try another charger first.

Nov 28, 2009 | MPC Computers TransPort T3000 Notebook

1 Answer

When I push the power button on my MPC t2000 laptop the fans come on and cdrom spins up but the bios does not show up nor the hard drive spin up


go to setup and see if the hard drive shows on it if not may be out. try to start on safe mode and see whaat happen

Nov 08, 2009 | MPC Computers TransPort T2000 Notebook

1 Answer

MPC Transport X1000. After replacing the dc jack I am now prompted for a password whenever I power on my laptop. I have removed both batteries that plug into the motherboard and all power and nothing has...


try to find a small batery inside netbook you find-it behind keybord or nerby cpu. you disconnect baterry about 10min. ALL THIS PROCEDURE WITHOUT BATERY AND MAIN CHANGER.

Note: All user bios config, are reset. You must config again.

Nov 01, 2009 | MPC Computers TransPort X1000 Notebook

1 Answer

My MPC t2300 laptop wom't turn on.


The Transport T2300 has an internal battery that will run the laptop for several minutes after the main battery goes dead. This feature allows you to save your work and shut down safely. If you run the laptop until both batteries are dead, even a brand new battery can't start the unit again. You have to follow this procedure:
1.Unplug power cord

2. Remove any attached periphal components including the cd rom and/or floppy disk module if you have one. Both remove with a push button switch located on the bottom of the unit.

3. Plug in power cord and charge the unit for a minimum of 24 hours straight. 30 hours is better. This whole time will be spent slowly recharging the internal back up battery.

4. Once that is done, unplug power cord again and reinstall any floppy/cd drives. Plug power cord back in now and charge for at least 24 hours again.

If your backup battery is dead, you can't charge the main battery or turn the unit on. The longer you charge, the better. We had one unit here that had to be on the initial battery backup for 72 hours before it finally took hold. Then, one overnight recharge on the regular battery and all was well.
If you need drivers or manuals for the 2300, all are available on cd at mpcsupport@cox.net for around $9.50 including shipping, handling, and owners manual

Apr 11, 2009 | MPC Computers TransPort T2300 Notebook

1 Answer

Hi I have an MPC Transport T2200 Laptop. I am running Windows Xp Pro sp2. I have a Samsung CDRW/DVD SN324F burner player. I can read and burn CD's fine, I can't read dvds, or movies. I had tried a couple...


You should remove the drivers(uninstall)and also in device manager unistall the player.reboot..download new drivers from samsung website.go into device manager and click on dvd player.update driver .This should correct it if not .let me know i will assist further.RICHARDM69

Dec 05, 2008 | Dell Inspiron 5100 Notebook

Not finding what you are looking for?
MPC Computers TransPort GX3 Notebook Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top MPC Computers PC Laptops Experts

Paul Bade

Level 3 Expert

1392 Answers

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

meteshadow

Level 3 Expert

489 Answers

Are you a MPC Computers PC Laptop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...