Question about JVC GR-DVX7 Mini DV Digital Camcorder

1 Answer

Gr-dvx7 jvc lcd screen is just white?

Hi when i turn on my machine it pwers uo ok and the lcd screen is on but it is just white i tried pressing all other buttons e.t.c but nothing helps or happens has anyone got any ideas whats wrong with it.... any advice would help thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 154 Answers
Re: gr-dvx7 jvc lcd screen is just white?

If the view finder shows the same white display. You probably have display circuit problem in the camera. Faulty CCD chip usually shows Black screen so it probably board problem or a connector problem. If you see an image through view finder then you may have defective connection from board to LCD assy. Either way it need to be looked at by a trained technician. Good luck.

Posted on Mar 18, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

LCD screen does not display anything

Hi ! No I think you need a new LCD sreen ! But I think a new Camera
is more efficient and cheaper !

Jun 08, 2014 | Sony Handycam DCR-DVD108 DVD Camcorder

1 Answer

My lcd screen is bright white and I cannot see anything, or do anything on my video camera. Is it totally wrecked?

Try resetting the Camcorder and check the operation. To reset the Camcorder, press the RESET button behind the LCD screen using a small pointed object.

Mar 05, 2012 | Sony DCR-SR47 Camcorder

1 Answer

Hi having problem setting date ,month ,time on camcorder . The touchscreen is not working when i press against screen

If the touch screen of the Camcorder is not working, please follow the troubleshooting steps.

Please make sure that you're using fully charged batteries.

Turn off the Camcorder and turn ON again and check the operation.

Try resetting the Camcorder by pressing the reset button behind the LCD panel.


Note: Please make sure that the Camcorder is turned ON while pressing the reset button.

If the issue persists again, please perform LCD screen Calibration and check if that helps.

Please follow the steps below to perform the LCD Calibration


Perform a power resetting of the Camcorder. To perform power resetting, please remove the battery pack, turn the Power switch to Play/EDIT/ON for more than 15 seconds, turn the Power switch to OFF position and then reinsert the battery pack.

If the issue persists even after performing all the above-mentioned steps, service is required.

I hope this information will help you to resolve the touch screen issue of the Camcorder.

Feb 22, 2011 | Sony Handycam DCR-HC20 Mini DV Digital...

1 Answer

My LCD touchscreen on my DCR-SR45 fades to white

To resolve the issue,

Please open the LCD screen to locate the RESET button.
To reset the Camcorder, just press the RESET button using a sharp-pointed object.
Please make sure that the Camcorder is turned on while pressing the RESET button.

If the issue still persists, Power Reset the camcorder.

To reset the Camcorder, please remove the batterypack from the Camcorder and then set the Power Switch to ON for 15 seconds.
Then, reinsert the batterypack after 1 minute and check if that helps.

Mar 20, 2010 | Video Cameras

10 Answers

My flip video camera wont turn on....

Have you tried resetting the camera? Hold down the power button and the red button simultaneously until the camera shuts off (takes about 10 seconds). Then, just press the power button again and the camera should turn back on. I had the same problem; when I pressed the red button to stop recording, the camera froze, and the red light remained on. I tried resetting it like this, and it seemed to work.

Jan 19, 2009 | Pure Digital Flip Video Ultra Camcorder

1 Answer

White LCD Screen on Sony Handycam DCR-HC21

check whether can see the picture through vew finder,if yes replace srtip wire from main board to lcd bord

Jan 10, 2009 | Sony Handycam DCR-HC21 Mini DV Digital...

2 Answers

Flip Camera Video Screen is white

buy a new one take the screen out of the new one and then swap screens take it back to walmart tell them it doesnt work and get your money back.

i would just say swap cameras but im sure theres serial numbers in these

Oct 07, 2008 | Pure Digital Flip Video Ultra Camcorder

2 Answers

DXG-506V LCD comes on Blank White Screen

I had the same problem ...I bought a new 2 GB SD card put it in the camera and it worked fine.

It may have had something to do with formatting ..I tried to format the other card wiyh my computer when the video camera would stay on.
I tried to reset the camera that didn't work either.
The new SD Card did work.

Jun 03, 2008 | DXG Technology DXG-506V DV Digital...

3 Answers

Touch panel menu unaccessible

Me too! The camera was working perfectly until yesterday and when I turned it on today, it selectively ignores some buttons on the screen - and pressing the "Menu" gives me nothing. I've tried to reset it through that pin hole button, but it just resets the machine back to its default.

Dec 13, 2007 | Sony HDR-HC1 Mini DV Digital Camcorder

1 Answer

Cannot use LCD for making inputs

it seems that the touch screen of your camera has damaged. Once replaced the camera will start working fine.

May 31, 2007 | Sony Handycam DCR-HC20 Mini DV Digital...

Not finding what you are looking for?
JVC GR-DVX7 Mini DV Digital Camcorder Logo

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Video Cameras Experts

Steven Wander
Steven Wander

Level 3 Expert

574 Answers

Larry Stiles
Larry Stiles

Level 2 Expert

286 Answers

Shekar Avadhani

Level 2 Expert

60 Answers

Are you a JVC Video Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides