Question about Car Audio & Video

1 Answer

Wireing dia for cdx l400x - Car Audio & Video

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

If your wires are white\w blk stripe gray\w blk stripe green\w blk stripe purple\w blk stripe the white and gray is front's green and purple are rear's white is right gray is left green is left purple's right

Posted on Dec 14, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Do you need to connect the yellow and red wires together if not used in a car on a pioneer DEH-X1950UB


Yellow - Connect to the constant 12 V supply terminal.
Red - Connect to terminal controlled by the ignition switch (12 V DC).

Jan 11, 2017 | Pioneer Car Audio & Video

1 Answer

I need operator's manual / instructions for Sony CDX-GT11W


The operating instructions and installation guide for the CDW-GT11W are available from the manufacturer's support site: https://esupport.sony.com/US/p/model-home.pl?mdl=CDXGT11W&template_id=1®ion_id=1&tab=manuals#/manualsTab . Click on the Manuals, Specs & Warranty tab. I needed to refresh the next page to download the manual (click on the circle with the arrow going clockwise). The direct link to the manual is currently https://docs.sony.com/release//CDXGT11W.pdf .

I hope this helps.

Cindy Wells

Jan 09, 2017 | Sony Car Audio & Video

1 Answer

I need operator's manual / instructions for Sony CDX-GTaaW


Try Googling (sony)(CDX-GTaaW)(manual) without parens.

Jan 09, 2017 | Sony Car Audio & Video

2 Answers

Where can I find the memory wire for the radio


Car radios don't have a 'memory wire'. Memory is held in integrated circuit chips called EPROMS, (electronically programmable, read only modules).

Jan 08, 2017 | Car Audio & Video

1 Answer

So how do wire this set set up to a bridged amp any help would be appreciated


assuming that is a dvc dual 4 ohm speaker, and you have a 2 ohm bridged amp, you run a positive from each side of the speaker into the bridged positive of the power amp, and run a negative from each side of the speaker into the negative bridged terminal of the amp. if, indeed, you have 2 4 ohm voice coils, running them bridged in parallel wiring will bring the load to 2 ohms. if you have 4 voice coils, of 4 ohms apiece, you could run all 4 parallel into the amp, but that would bring the load down to 1 ohm, and you would have to make sure you8r amp can support 1 ohm operation.

Jan 07, 2017 | Car Audio & Video

1 Answer

I have a boss 400w riot 2-4 channels,how do i connect the high level wires? Because stereo doesn't have rca's


to use the high level leads, you have to isolate the wires going to each speaker (if using 4 channel mode) or isolate the wires going just to the rear if you are using 2 channel mode. you have to strip a small piece of the insulation off each speaker wire, and run it into the amps high level input harness. if you dont have the high level input harness, you can get a 2 channel high level to rca adapter for around $20. basically, you are tapping into the signal to the stock speakers to feed music to the amp. make sure you get all your positives and negatives correct. brighter wires are usually positive; however you may be faced with sa speaker which uses a grey wire, and another grey wire- the second with a black line. you will have to, again, turn to internet research to determine which is positive and negative, if the colors are not obvious.

Dec 30, 2016 | Boss Car Audio & Video

1 Answer

Car radio not turning off when the car is turn off


This has to do with the way the radio is wired. It's best to go into a motor-mechanics or car-audio shop to have them wire it correctly

Jun 09, 2014 | Car Audio & Video

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4766 Answers

yadayada
yadayada

Level 3 Expert

67930 Answers

The Knight
The Knight

Level 3 Expert

71705 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...