Question about Carlton HES-40 4,500-BTU ELECTRIC STOVE Heater

1 Answer

The light has gone out on my model hes 40. Is there a fix?

The light has gone out on the stove. Can it  be repaired?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Contributor
  • 1,199 Answers

YES!

Posted on Dec 14, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mitsubishi slit air conditioner model MSZ-GA80VA I turn on and turn off cauting out door unit fuse blown I replaced still The fuse is blow is the out door air con unit Note.unit in door stop not inpos


turn off everything electrical in house and retry with good fuse or breaker if still blows unit needs repair possible shorted capacitor? if it runs it may need to be on its own circuit dedicated to it alone

Jan 05, 2017 | Mitsubishi Heating & Cooling

1 Answer

I have a older Carrier heat pump, model 38YKC060. Does anyone know how cold it will continue to work at?


Heat pumps are of little or no value at temps around 40 degrees or below. And if you use the strips it will cost a small fortune if you have relatively high electric rates as most folks do.

Jan 04, 2017 | Heating & Cooling

1 Answer

The pilot lights are shooting out flame. How donI fix?


Don't understand......pilot light IS a flame. What is the problem? Is the flame lazy and big? Then the pilot hole is dirty. don-ohio

Jan 04, 2017 | Heating & Cooling

1 Answer

My Coleman furnace 4322/729 model lights the pilot but won't cut in . What could be problem ? Cleared lines Complete


Gas valve not opening? Does it have the exhaust blower that pulls vacuum switch allowing burner to light?
(1) Thermostat not working? Has to complete the circuit in or gas valve to open.
(2)Can be a stuck or bad gas valve. Try tapping the side of the gas valve body while thermostat is calling for heat. Tapping,not pounding. Like lightly,yannow? don-ohio (:^)

Jan 03, 2017 | Coleman Heating & Cooling

1 Answer

Kenwood Electric Oil Heater. Model EW7507EK. Can anyone tell me what color order of wires onto the circuit board? I feel like an silly for not taking a photo before starting the repair. F3-5


Look carefully on the board itself. Sometimes the wire color codes are labeled right next to the connector. If not, there may be some other letter codes and these should match the ones on the thermostat.

Dec 22, 2016 | Kenwood EW7507EK Oil Radiator

1 Answer

No steam coming out from steam cleaner


I know its a silly question but is it plugged in? and does it have water in it? Is there any lights on it to show that power is on? Have you plugged it in elsewhere? If no power light on check the fuse in the plug, only replace it with one of the same rating. If this cures the problem and the power light is on, it should be working, if it blows the fuse again then it has a short and needs repairing or replacing

Jan 03, 2015 | Heating & Cooling

1 Answer

Is it cost effective to replace draft inducer blower on 22 year old furnace?


Depends on the cost to repair. Probably a 22 year old furnace is not very efficient also. Take every thing into consideration.
If it still works it may work for a while but you don't want a break down in the middle of winter.

Nov 07, 2014 | Heating & Cooling

1 Answer

My Oreck Steam-It cleaner is not steaming


i have a steamer my self it works well to till it runs out of water just take it back to where u got it or call who u bought if from an tell them what its doing they should replace it god bless you jesus loves you j316 kjb hes come ing soon

May 25, 2012 | Heating & Cooling

5 Answers

E1 and E4 error code desplay on the screen induction cooker. what is the fault in the induction cooker?


E0 error - ensure pot or pan is placed correctly
E1 error - the circuit has malfunctioned
E2 error - the temperature sensor is opening circuit or short circuit
E3 error - the voltage is higher (140 - 160V) for 3 seconds
E4 error - the voltage is lower (80 - 100V) for 3 seconds
E5 error - the cooktop surface temperature is too high
E6 error - Internal electronic temperature is higher than normal for 3 seconds
E7 error - Internal electronic temperature sensor is opening circuit or short circuit

Dec 12, 2010 | Stoves Heating & Cooling

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Carlton Heating & Cooling Experts

paulcarew

Level 3 Expert

2046 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Cris Sparks
Cris Sparks

Level 2 Expert

338 Answers

Are you a Carlton Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...