Wax fell on grill and is inside grill- should i get this looked at and fixed?

Disassembly will be necessary.

Remove the motor cover and look for the Wax lift board , it's right by the motor controller and check all wiring going to it.

Could try grim and wax remover/prep for auto bodies. Auto stores have it. Then polish/ wax the spot.

I have searched all my reliable sources, but can not find the Owners Manual for that model Ducane. Gas Grill. The problem is it's just to old. However, Weber bought Ducane in 2000. Possibly, they may still have copies of the Owner's Manual. Call Customer Service 1-800-382-2637.

Remove the offending burner, check it for crimps or debris inside that was dislodged when it fell over. Also check the venturi valve on the open end of the burner for damage or blockage. While the burner is out, look at the burner orifice to make sue it's still in place and not clogged. If all of the aforementioned checks out Ok, the burner manifold valve may have gotten damaged beyond repair and will need to be replaced.

Hope this helps you to troubleshoot and solve the problem.

Music City Metals has your part# 03200

take the control panel apart
3 small screws on top
look for the control board
your looking for any obvious signs of burn
thats the lock resistor r-11
you will need two parts here
a wax motor and machine control board
the wax motor was your problem
it took out the board
1999 sounds like the mah3000
ive included the part numbers for that model

AP4026826 machine control 181.00
AP4026523 wax motor 11.97

call
1-877-477-7278
two part repair but a 5 on a difficulty outa 10

My grill has also fallen off twice. It usually results in the tabs breaking off. My solution has been to add tiny (1/2" x 1") shims in the slots where the tabs have broken. Look carefully. There are two tiny channels. I wedged the wood in and then reattached the grill using sheet metal screws in the same screw holes. It won't come down again. In three years since doing the kitchen with all KA appliances we have replaced the grill once. We had the stove removed and replaced by the appliance company at no charge after 4 months. We had our ice maker replaced out of warranty. I would never recommend KA appliances to anyone. The quality is absolutely terrible.

I have a Foreman GRP99 that has a broken Grill Plate Handle.
I called 1-800-233-9054, Fox-International, and ordered a new handle for $14.95 including Shipping.
Maybe they have support advice?
Dave in Ohio

This should be a very easy fix. I assume you are talking about the plastic vent grill on the top of the oven above the door. There should only be a couple of screws holding it in from the top. The grill then should tilt out from the top first then from the bottom to remove. Since you said that it had fallen off, it sounds like the tabs where the screw holes are have broken off. This is a common problem. You can buy the part by ordering from the manufacturer, or from most repair websites. All you need is the model number from the microwave. Good luck.