Question about Whirlpool Ultimate Care II LSQ9549L Top Load Washer

1 Answer

Whirlpool Top Load Washer Fills With Water and Stops, Won't Drain

My Whirlpool Top Load Washer Fills With Water, Stops and Doesn't Drain Even Though the Knob Continues to Turn. If I Turn the Knob to Drain, it Will Drain for MAYBE 10 Seconds and Then Stops Again. I Thought it Might be the Lid Starter Switch, so I Looked at it and one of the Connections Appers to be Discolored, Almost a Burnt Brown Color. Could this Be the problem? If not, what do you think it could be?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 85 Answers

You could have a broken mtr coupling

Posted on Dec 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WASHER FILLS WITH WATER, THEN WON'T AGITATE. TURN KNOB TO SPIN AND IT DRAINS THEN SPINS. STILL WON'T AGITATE


WASHER FILLS WITH WATER, THEN WON'T AGITATE. TURN KNOB TO SPIN AND IT DRAINS THEN SPINS. STILL WON'T AGITATE please show me a diagram

Jun 14, 2011 | Whirlpool LSR7333 Top Load Washer

1 Answer

Cycle stops motor hums whirlpool top load


bad points in timer or bad motor take the motor out and to a used washer shop and see if they will test it for you for a small fee if it tests ok get a timer

Dec 25, 2009 | Whirlpool Washing Machines

1 Answer

Washer will not fill up!


The water is siphoning out as it fills. Your drain hose is too low or has a air block. Remove the drain hose from the drain. Set the washer to fill. Hold the drain hose up higher than the washer. If it fills correctly and starts agitating,correct the drain hose problem.

Sep 23, 2009 | Admiral AW22 Top Load Washer

1 Answer

Not spinning or draining, only fills and agitates


the mixing valve in the rear needs to be repaced-it controls the water flow Also sounds like the clutch of the transmision maybe be a factor if the machine doesn't spin

Jul 25, 2009 | Whirlpool Cabrio WTW6600SBT Top Load...

2 Answers

LTE6234 Whirlpool Twin Thin Timer Broken?


Check for voltage at the water inlet valve with the timer dial pushed in or in an off position. If no voltage replace the water valve. If you do have voltage you'll have to trace the circuits back from the water valve to the line. One point of demarcation is the water level switch. Pull the violet colored wire and see if it still fills while off. If it does it's likely the timer's bad.

Jan 31, 2008 | Whirlpool LTE6234D Top Load Stacked...

1 Answer

Water won't drain out


Possible lid lock, check the lid is locked when it should be spinning or pump jammed and check the draim filter. Regards Advisor

Sep 01, 2007 | Whirlpool Ultimate Care II LSQ9564J Top...

Not finding what you are looking for?
Whirlpool Ultimate Care II LSQ9549L Top Load Washer Logo

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...