Question about Vector Manufacturing Simple Start Battery Booster Car Starter

Open Question

REPLACEMENT PART BLACK & DECKER VEC012CBD Jump-Starter/Air Compressor I am trying to locate power cord

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery not charging on my asur laptop note book R530U


Battery needs replacement if it does not take charge with known good power cord.

Nov 14, 2013 | Batteries & Accessories

1 Answer

I Have a Vector VEC011 Jump Start System and the battery has gone bad. Where can I find a replacement battery (12V, 9A) with Bolt on bus Terminals


In March, 2006, Black & Decker purchased Vector Products, Inc. Since the acquisition, Black & Decker has assumed the manufacturing of all Vector products. For customer service and warranty information for Vector products, please contact Black & Decker Customer Service.

Or, you may find a replacement battery here: http://www.batterywholesale.com/battery-store/SLA-batteries/

Sep 25, 2010 | Vector Manufacturing Simple Start Battery...

1 Answer

Good day I've had the unit plug in for 48 hrs and


In March, 2006, Black & Decker purchased Vector Products, Inc. Since the acquisition, Black & Decker has assumed the manufacturing of all Vector products. For customer service and warranty information for Vector products, please contact Black & Decker Customer Service.


Aug 08, 2010 | Vector Manufacturing Simple Start Battery...

1 Answer

Air Conditioner Breaker Tripping


This is a tough one to diagnose without seeing the panel. It's the main breaker or just the a/c breaker? The easiest diagnosis is to put an amprobe on the black wire coming off the a/c breaker (Harbor Freight about $12.) to see how much current it's drawing. It should be less than the rating of the breaker (shown on the end of the handle). Make sure the thermostat is all the way down so the compressor is running.This is a likely solution because a high current draw can be caused by anything from leaves laying in the bottom of the shroud to a compressor starting to go bad. If that amperage is lower than the breaker rating and it trip's it's probably just a bad breaker.Another cheap fix. I would have to assume the rv dealer tried this so we can move on but it is the best starting point. Loose wires anywhere in that panel can also transfer heat through the buss bars. Unplug your power source and tighten all connections. The panel won't get warm until its been on a while and heat is what causes the breakers to trip. Again I assume the dealer would have tried that but I'm trying to cover all options. The last thing I can come up with is maybe the RV dealer isn't putting the cover back on the panel while troubleshooting which stops it from building up heat. Without the additional heat build-up the breaker won't trip. The inside of the breaker is two metals sandwiched together designed to bend when they get warm. When they get warm enough (caused by the rated current flowing through the breaker) they bend enough to push a button to trip the breaker handle. Try these out and let me know if it works.

Nov 22, 2008 | Batteries & Accessories

1 Answer

I have a car jump starter unit that was left and went dead flat. Now it will not take a charge pluging in the charger?


Unfortunately, a Jump Starting Unit which no longer takes a charge usually means the internal batteries had gone bad. On some charging units, the replacement batteries are available through the manufacturer, but more times than not, it's less expensive to replace the Jump Starting Unit.

Nov 09, 2008 | Energizer Rechargable Battery with Charger

1 Answer

Black and Decker Battery Charger


Fault Codes Meaning of Fault Code F01 Internal Shorted Cell Battery - Cannot be charged. Have battery checked by certified auto service center.
Excessive Load on Battery While Charging - Check load. F02 Bad Battery Connection - Check battery connection.
Battery Voltage Tool Low to Accept Charge - Have battery checked by certified auto service repair. F03 Internal Open Cell - Have battery checked by certified auto service center.
Sulfated Condition - Battery needs to be reconditioned. See manual. F04 Overtime Condition - Battery will not accept a charge after 18 hours of continous charging. Battery may have internal
damage. Have battery checked by certified auto center.

Battery Charge Rate is Set Too Low - Set charger to higher charge rate. See manual. F05 Overheated Condition - Disconnect charger and allow to cool for 30 minutes. Check for ample ventilation. F06 Reverse Polarity F07 Alternator Output is Out of Typical Operation Range

Operation Codes I=I=I=I Battery Reconditioning - (The letters DES will display for the first three seconds) I-I-I-I Alternator Voltage Check OOO Charger Standby FUL Battery Fully Charged

Sep 21, 2008 | Batteries & Accessories

Not finding what you are looking for?
Vector Manufacturing Simple Start Battery Booster Car Starter Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vector Batteries & Accessories Experts

Carl Glas
Carl Glas

Level 2 Expert

283 Answers

kakima

Level 3 Expert

96664 Answers

Jay Finke
Jay Finke

Level 3 Expert

1222 Answers

Are you a Vector Battery and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...