I removed the cable from microphone circuit board and shortened cable by 20 cm. to eliminate damaged wires, stripped the individual wires and soldered the pins to the new wire ends and reassembled. Used black heat shrink tubing [10mm dia.] to reinforce cable end at mic to prevent future damage from careless handling.
Document wire colours to pins before disassembly
Red Audio L White Audio R Blue DC Power Shield [ground] Ground Yellow Video
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Technician (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
good day, How long your washing machine? for the machine without power if electronic type of washing machine it will cost you a lot but defend on the model. and not to advise to buy the part without any idea what the exactly the problem,most the electronic type washing machine have a PCB problem, if you buy directly for the part but you dont have the cause why it happen,may be if you put new part will do the same or its will waste your new part. as an advise as a technician,call the technician and ask how much its cost? for labor and part? if the cost is halt price of the unit? what or how many month for warranty for the part and service? make think to buy for the new one if your unit is more than 5 years.
the problem is solved by expert electronic, because your tv have cpu program and need reconfiguration this program, And other question is you check cable conexion you check conexion you check format/image programing (NTSC/PAL) if in the setup or menu have the best configuration, no all problem is the component electronic... oh, you read manual step by step...
We had this problem too. Can you perform any functions with the duet mic? We couldn't, just had the light flashing. Turns out the light is supposed to flash (never is solid). Check the connections to the sub mic pack in the back of the main mic. Ours was loose. Once that was plugged in properly, we turned everything off and started again. All was fine.
We had the same problem just this weekend. However, we investigated it ourselves and discovered that you can take the microphone apart by unscrewing the two small screws inside the mic, under the music chips. Once the screws are out pry the two halves apart very carefully. Once we were inside, we discovered that the soundcard was loose and all we had to do is plug the sound card back in. Close 'er up and start up the show. Good Luck!
I removed the cover on the back (the access to musicartridges) I also removed wireless receiver unit (approx 2" black plastic piece) pull straight up to remove. after removing the receiver you'll see two screws, remove them, unscrew the mic head, pry the body apart (fingernails). You will see two circuit boards, the smaller one became disconnected. The board should reconnect easily, the outlet looks almost like the wireless receiver outlet you removed earlier. if it does not slide in easily DON"T force it, you may be trying to install into receiver outlet ( They look the same), The correct outlet is above (towards mic head) the four outlets to the music cartridges. CAREFUL NOT TO BEND PINS same with the wireless receiver.