Hitachi 50GX30B I need to align Digital Array no original remote

post the model number of your Hitachi and I will post the instructions for controlling the array with your remote.

Setup codes to check with Hitachi tV are:
0088 0059 0142 0060 0072 0004 0009 0091 0001 0012 0061 0137 0139 0141 0179 0227

Replace both of the convergence ICs. STK392-110 use 120s Mats
1-800-628-1118

The best source I have found for original remotes:
Remotes
Expect to pay for it though-

Go to www.remotes.com to order a new remote. I ordered one there and was very satisfied with the speedy delivery and guarantee that it will work for your system. Cost me $62.45 shipping included. Mind you it was shipped from Portland Oregon to New Brunswick Canada, so it was a fair price by comparison.

Hope this helps....

Try www.remotes.com in Portland Oregon. I bought one on-line from them and it comes with a guarantee to work, as well as new batteries all installed. Cost me $62,45 but worth it since you can only make adjustments with the remote (as long as it isn't too extreme) then you need to get hold of a service manual (which I am still hunting for)

my t v set is bowing at the top and some on the bottom.When go to adjust the x's they don't match up.

Replace IK04 and IK05, both STK392-110, but use instead STK392-150's for greater reliability. And don't get some Chineese knock-offs - use original Sanyo replacements. If you don't know where to get those try ACME Enterprises in Florida,
http://www.acme-sales.net/index.shtml
Also measure the low ohm feed resistors in that circuit. However usually just replacing the convergence amps will restore normal video...
Bill

press menu on the remote and then u will be able to align the blue

I have the very same problem. Was there a solution to landfill2004?