Question about Furuno NavNet vx2 1920C GPS Receiver

1 Answer

My ais targets are out of line showing them out of the river

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If the AIS targets are out compared with radar target then turn compass to superimpose radar on to AIS.
If the AIS info is out compared with chart then suspect GPS. This could be yours or theirs depending on how many targets are out and whether it consistantly in one direction.
Good luck
Mike

Posted on Dec 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is Gotham City located?


Gotham City is a fictional U.S. port city located on the north-eastern Atlantic coast. It was originally a stand-in for New York City, but has also resembled other crime-ridden urban centers such as Chicago and Detroit. Some sources, including Mayfair Games' authorized (but now out-of-print) Atlas of the DC Universe, have placed Gotham City in the state of New Jersey. Batman: The Animated Series shows Gotham City in New York State on the western tip of Long Island.Christopher Nolan's (director for Batman Begins and The Dark Knight) Gotham City is located in the middle of the estuary of the Liberty River, where it empties into the Atlantic Ocean. The river separates most of Gotham from the mainland. The River Merchant divides Uptown from Midtown, while Midtown is separated from Downtown by the Gotham River. The Narrows is a small island in the Gotham River. A creek divides the district of South Hinkley from the rest of Gotham City. Gotham International Airport is in Pettsburg, to the north of the Liberty River estuary. The current DC Universe version of Gotham City is separated from the mainland by the Gotham River, bridged by a series of bridges and tunnels. The east and south sides of Gotham face the Atlantic Ocean. The city is further divided by the Sprang River (named for Dick Sprang) on the northern end and the Finger River (for Bill Finger) to the south. Tiny Blackgate Isle to the south-east is home to Blackgate Maximum Security Penitentiary. (Blackgate is replaced by Stonegate Penitentiary in the animated series "Batman" (1992) and its spin-offs.)

Sep 04, 2016 | Batman: The Animated Series (1992)

1 Answer

I need to find out what someone's direct line is. I have an extension assigned with a mailbox but not sure of the direct line # associated with the extension. How can I find out?


This would depend on if the line is a stand alone line only being assigned to one extension or on a PRI having DID service. Do a Feature *0 and check the line buttons. It will show the line number or target line number. With this information you can check it in one of two ways. If it is a stand alone line and provided a line number, access the line by pressing the line and dialing your cell phone to get the Caller ID information. If it associated with a PRI having DID service, you will have to check the target line information in programming. A system administrator or vendor needs to do this.

Aug 30, 2013 | NorStar Lands Phones

1 Answer

I have a Mitsubishi eclipse 95 and the check engine light codes are 12, 25,41, and 55. So what's wrong with my car??? I can't find what these codes mean


Hi there:

Code 12 - Battery or power line recently disconnected - This code is normal if the electrical system has been worked on or the battery has recently been disconnected. It will be removed after 15 ignition switch on/off cycles.


Code 25 - AIS (Automatic Idle Speed) motor circuit shorted or target idle speed not reached


Possible Causes:
- Vaccum leak - Check all vaccum lines for cracks or breaks.
- Bad connection or wiring - Check the wiring and connections between the logic module and the motor. Clean and regrease any corroded connectors with dielectric grease and repair any shorts.
- Shorted or frozen AIS motor - The AIS motor is located near the TPS. For 1987 or earlier Turbo I engines, remove the bolt and slide the motor out (you may have to wiggle and twist it). Remove the clamp and carefully pull out the motor. Be sure and observe how it goes together, especially the orienation of the rotatiing valve inside. Hook the motor to a 12V supply to see if it runs. If it doesn't, replace the AIS. Clean all the gears and shafts throughly and reassemble the gear and valve assembly. Spray all the gears and parts with TriFlo or a similar silicone spray lubricant (don't use WD40 because it evaporates) and insert the motor. If the engine seems to race wildly after assembly (give it some time to get control), you probably installed the internal, rotating valve backwards.


Code 41 - Alternator field control circuit open or shorted

Possible Causes:
- Bad connection or wiring - Check the wiring and connections between the logic module and the power module. Clean and regrease any corroded connectors with dielectric grease and repair any shorts.
- Bad voltage regulator circuit


Code 55 - End of message
No further fault codes are stored. If this is the only code received, then there are no codes stored in memory. This code will always be given, even if nothing is wrong. If you do not get this code, then you may not be retreiving the codes properly, or the power loss light may be burnt out. The light should come on for 1 second when the ignition is initally turned on as a bulb test.




Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Oct 31, 2012 | Cars & Trucks

1 Answer

Can it take ais?


Hello,
A Standard-Horizon CP180 Chartplotter can recieve information from an external AIS device with a NMEA data wire connection. The cable from the NMEA output of the AIS would be connected to "Port 1" (Page 18 of the CP180 user manual) on the CP180 and then the CP180 menu settings configured to show AIS targets, data, etc. (Page 21 on the CP180 user manual)

Nov 19, 2010 | Standard Horizon Cp180 Chartplotter

1 Answer

What is Ai net


ai net is simply alpine's upper level line of decks. they have their regular line and ai net line. just like kenwood has their normal line and their upper level excelon line. ai net uses different cables to connect with changers and aux items than the regular line.

Apr 18, 2010 | Alpine CDA-9883 CD Player

1 Answer

I am getting fault codes 34, 53 & 25 on a '93 dodge dakota 3.9L magnum...could you tell me what problems these codes specifically refer to so that I can fix the problems?


25 Automatic Idle Speed (AIS) motor driver circuit shorted or target idle not reached, vaccum leak found 53 Logic module internal problem


have you tried to reboot the ECU by removing the pos battery terminal for a few minutes

Nov 30, 2009 | 1993 Dodge Dakota

1 Answer

Want to know if I can use the line-level inputs from the CD Chgr


Your alpine unit is the old "M-BUS" the other adapter you are talking about is an "AI-BUS" adapter. (Hence the model numbers beginning with CD"M" or CD"A" ...)

Look for an Alpine M-Bus to RCA Input adapter.

heres one on eay for less than 10.00 including shipping.

http://cgi.ebay.com/For-Alpine-M-Bus-to-stereo-RCA-adapter-cord-cable-8-pin_W0QQitemZ310117370938QQihZ021QQcategoryZ60208QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Feb 09, 2009 | Alpine CDM-7857 CD Player

Not finding what you are looking for?
Furuno NavNet  vx2 1920C GPS Receiver Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Furuno GPS Experts

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Cindy Wells

Level 3 Expert

4846 Answers

Steve
Steve

Level 3 Expert

688 Answers

Are you a Furuno GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...