Question about Sharp Aquos LC-32D40U Television

2 Answers

No sound sharp lc-32sb23u was turned on this morning - no sound mute is not on audio setting is ok (back to factory reset) turn off and on but no difference any ideas?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 33 Answers

Please try unplugging the TV for two minutes then replugging and turning it back on. Werked fir me!

Posted on Jan 13, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 125 Answers

Audio problem , the audio circuit is bad. try hooking up the cable box if you are using one to any stereo system

Posted on Dec 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is the audio amp on the main board of a sharp lcd tv


A manual for a measure of the voltage line thats goes to the audioboard and there can be used a fuseresistor a resistor to protect the audioboard if .......
SHARP LC 32M44L LC 32SBB21U LC 32SB23U LC 32SB220U SUPP Service Manual...

Suc6

Oct 25, 2015 | Sharp LC-32SB23U 32 in. LCD TV

1 Answer

Sound stopped working on sharp Aquos LCD television


Check the speaker/s first. If found OK; check and replace the damaged component/s at its audio output section circuit board. If needy, replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. Surf the site with patience.
http://electronicshelponline.blogspot.com/

Oct 10, 2014 | Flat Panel Televisions

1 Answer

No sound on my sharp aquos lc-45gd4u 45 in


Assuming you are using the internal speakers, check and make sure you have the audio enabled. Some TV sets have a option to turn off the internal speakers. Also make sure mute isn't turned on. If you are using external audio setup, double check your connections.

Nov 24, 2012 | Sharp Aquos LC-45GD4U 45 in. LCD HDTV

1 Answer

I plug in the cable/antennae wire and it freezes up. I can't change channels or anything. if I unplug it it changes fine, then of course I can't watch tv. I have a sharp lc-s3sb23u.


See if Sharp's customer service still walks customers through what is called an INIT or factory reset. 800-BE-SHARP. Make the television do what it does when it freezes up and then call. You might just need to scrap the television because if you need another main board the part alone will cost around $600.

Sep 20, 2011 | Sharp LC-32SB23U 32 in. LCD TV

1 Answer

No picture


It sounds like the Bluray player may be outputting the signal at a higher resolution than the TV supports. If the Bluray player has a scart or composite connection, connect with those first, and adjust its settings to output a lower resolution. Then reconnect the HDMI. Hope this works for you.

Jul 17, 2010 | Sharp LC-32SB23U 32 in. LCD TV

2 Answers

The power light blinks and the tv doesn't turn on


you should perform the initialization to factory defaults.

May 24, 2010 | Sharp LC-32SB23U 32 in. LCD TV

1 Answer

Tv takes forever to turn on sharp television LC-32SB23U


This problems very common with sharp tv.The Main Turner Signal board have problems.Keep using it,when it stop and completely dead 20-30 on-off no backlight show up and picture.U know ur Tuner board signal board is dead, have to replaced it.

Jan 06, 2010 | Sharp LC-32SB23U 32 in. LCD TV

1 Answer

I have a Sharp 32 inch 720p tv, power works, no other buttons do


Unplug TV set from the outlet, wait 30 seconds, plug it back in, select right input with your remote if you using cable box or Punch the channel that you want to watch if you have cable service connected directly to the TV.

Nov 05, 2009 | Sharp LC-32SB23U 32 in. LCD TV

1 Answer

Sharp aquos 37" has picture but no sound ? unplugged and changed audio back to factory settings still no sound? is there a fuse some were for the sound card ?


Try the main resets in the back by the a/v in and out jacks. If this does not work, call Sharp Customer Service and tell them that you already did the resets. There is a known problem with a heat dissipation pad and they will send a repair tech to replace the pad for free, even if you are out of warranty. At least that was the case for my LC-32D6U.

Jun 18, 2009 | Sharp Aquos LC-37GD6U 37 in. LCD HDTV

1 Answer

Connecting external speakers to Sharp LC-32SB23U


Invest in a sharp soundbar (about $175.00) matchs the cecor of the TV fits right at the bottom and looks like part of the TV and the sound is super.

Jan 04, 2009 | Sharp Flat Panel Televisions

Not finding what you are looking for?
Flat Panel Televisions Logo

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Flat Panel Televisions Experts

The Knight
The Knight

Level 3 Expert

68352 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

Are you a Sharp Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...