Question about Acer AC713 17" CRT Monitor

1 Answer

ACER AC213 Dog chewed the socket of the lead, need to know the wiring diagram for this unit.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 151 Answers
Re: ACER AC213

Hope this be of initial help/idea. Pls post back as requested, how things turned up or should you need additional information. Good luck and kind regards.

Posted on Mar 14, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Green lines in left side of screen.In paralel and horizontal position

If the monitor does the same thing or similar on another computer its the monitor or vga lead at fault
Check first, the security of the connections from the computer to the monitor, these need to be tight to avoid loose connections and therefore signal loss, id these are ok, check the condition of the vga cable, look for splits cracks and bent pins on the end of the lead, check also the socket condition of the monitor, if any pins on the lead are damaged, discard and replace the lead

If the monitor signal is ok on another computer, check the graphics card / connection to graphics port on the computer, could be this is faulty.

Now check the monitor by resetting to factory settings and pressing the degauss button, check also that there are no magnetic devices like speakers near the monitor.

After those checks it still occurs, the monitor is failing and will need replaced

Jul 28, 2011 | Acer Value AL1703SM 17" LCD Monitor

1 Answer

I just moved my Acer 19" monitor and everything went off. I checked all the connections but it is not turning on. any suggestions?

Check the VGA lead, it is possible that when moving the monitor, you damaged one of the pins that connects in the socket on the monitor, remove the lead and also inspect the socket if there is a broken pin inside it remove this and try a new vga lead.

If no pins are broken and / or the power is not even reaching the monitor, check the kettle lead, look for signs of damage to the rubber / plastic plug and the socket on the monitor (assume this one is fed directly from the mains?), If you have been unfortunate enough to have damaged one of the pins that is in the socket you will need a TV repairman to fix this.

Check also the condition of the lead itself, for breaks and whether the fuse in the plug has blown.

After that, your problem will need to be looked at by a qualified TV repairman, as the fault must lie on the board itself

Jul 26, 2011 | Acer Computer Monitors

1 Answer

Dog chewed cord in half. Not power cord - feed cord. I have it apart, where can I get a new cord. Its a Dell flat screen monitor- Model :E151FPb

You need a DB15 Video cable, they are available at say... Radio Shack, or the like, any good PC store should have them.

Feb 21, 2010 | Gateway FPD2275W LCD Monitor

1 Answer

I have an Acer 24" wide screen LCD monitor. When it sits idle for awhile it puts itself into sleep mode. Usually you would only need to touch the keyboard or mouse & the monitor would revive, a week...

jlichtenegge, Wish all lcd monitor problem descriptions where as good as you have done!!! Here are some suggestions. Use ACER warranty first if valid!!!! If warranty not an option, then do cash+old unit swap for a refurbished same model if ACER has a swapout program for infantile failed units. (short SMPS/CCFL inverter board lifespan) If monitor DOWN TIME is super critical then you or local electronics technician will need to DIY repair unit by resoldering the thermally fractured intermittant soldered to board component lead that is causing "switch-mode-power-supply" to go into full or partial shutdown mode. You may need an inspection grade microscope to visually locate the oxidized intermittant connection. Let me (lmistyrel on know what you intend to do fmi Hope this helps. Read more of my fixya profile to get more of a handle on this type of failure. Bye for now.

Jan 26, 2010 | Acer Computer Monitors

1 Answer

Where do you connect the speakers to an Acer X193HQB screen. There doesn't appear to be any spare sockets to connect anything.

there is no need another wire of sound for lcd monnitor go control panel and set sound option from speaker and sound

Oct 25, 2009 | Acer X193W LCD Monitor

1 Answer

The cable has been cut off of my acer monitor (v771-m) I took the back off the monitor and want to fit another cable from a different make, can someone tell me which colour wires go to which pin on the...

Have you already removed the wire from the back of the monitor or have you already replaced the wire and now want to reconnect the 15 pin D-type plug?

If its just the D-type you want to reconnect then have a look here:

Its not the easiest diagram to follow but all you need to remember is that some wires are used and some are not.

If you dont have a particular colour of wire then it probably isnt used.

I hope that helps...



May 12, 2009 | Acer Value V771 (White) 17 in.CRT...

1 Answer

My wifes dog chewed the cable that is hard wired into the lcd .

If it's the screw on type on both ends (I'm assuming it's the video cable), you can unscrew both ends and get another VGA cable (under 10 dollars each).
If not, you might want to consider keeping the dog away from cables, it was lucky not to chew on charged wires.

Dec 14, 2008 | NEC MultiSync LCD1512 Monitor

1 Answer

No Power

have you tried to find the manufacturers site, to see if they have a replacement Board.
if not try to locate an electrical repair centre, and get a quote for having the board repaired.
p.s get a metal outer cable, the dog will bust it,s teeth next time :)
Mike @ Compurepair.

Feb 10, 2008 | Gateway FPD1760 17" LCD Monitor

1 Answer

Need help finding replacement monitor cable

what color are the ends of the cables, blue you need a vga cable, white a DVI cable- there are two types of dvi cables look at the connector if it has a plus sign in it you need a dual link otherwise a single.

Oct 26, 2007 | ViewSonic G790 19" CRT Monitor

Not finding what you are looking for?
Acer AC713 17" CRT Monitor Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acer Computer Monitors Experts

Steven Wander
Steven Wander

Level 3 Expert

574 Answers

 Mike M
Mike M

Level 3 Expert

3320 Answers


Level 2 Expert

49 Answers

Are you an Acer Computer Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides