Dishwashers used to come with several color panels under the white one. Remove the trim around the door, and see if there is one or more panels under the exposed panel. Used to be brown, avocado, copper, etc.
An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: wrong color bought
Hello, Welcome to Fixya,
You can buy appliance paint in a spray can. I did the spray can on an appliance once. Just do slow even coats very thin coats so you do not put to much on at one time. Or the manufacture may have a trim kit and you can put a panel on the front with a trim kit to hold it!
Or if it is new return it to the store all big stores do returns now a days!
let me know how it goes
Please remember to leave a rating before you go! Huum
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
most defrost timers are located inside cardboard cover near back side of refrigerator, mostly mounted in vicinity of compressor. Most are white in color ( I have seen other colors) and have a multi prong connector with 4 leads.
If there is something on the frost of the filter you can grab onto with plier you should be able to pull out the filter. Withthe broken can the button wont push in since the cap locks into the latch for the filter These are the part's for the cap all are the same except letter at end indicates color
2260518W white 2260518B black 2260518AP grey 2260518T almond/tan
It could be purchased at your local appliance parts store or online at, searspartsdirect.com apdepot.com apwagner.com repairclinic.com midwestapplianceparts.com Good luck in getting the filter out, Gene
we all get a bit discolered after 10 years.bottom line the paint sort of gets thin and worn.cheer up take them off or mask-tape them and with a little very fine sandpaper give them a little rub and repaint them to match your new and very expensive kitchen.adrian,,,,
Depending on the model, and the color, here's your fix.
Stainless with stainless handles- you'll need a hex key. The tiny hole is on the inside of the handle, close to the center. Turn the key until it's tightened.
Stainless with black handle/white/bisque/black- push the door handle up. Careful not to scratch the finish! once the handle pops, pull it straight off. Take a phillips head screw driver, tighten the top screw A LITTLE BIT and then attach again. Insert screws on the door into the holes on the handle, slide down. (will need to be a little tough with it.) Good luck!
Dont let that scratch get ya down. It is really easy to get that scratch fixed. You will first need to buy you some appliance touchup paint. You can get a small bottle about the size of a nail polish. It even has a little brush inside like nail polish. If you get the correct color just brush a little into the scratch and viola, all better. If you have a stainless steel refrigerator that scratch is going to be a part of your life as long as you own the refrigerator. Good luck to ya and remember when you are buying your touchup you may need to order for the brand and color not just the color. Whirlpool bisque may be different than frigidaire bisque. Also you may want to practice your painting technique on a hidden spot before you jump in. Keep a clean cloth on hand also incase you have a run, just wipe it off and start again. See ya... MCA0824@aol.com