Question about Alpine Car Speakers & Subwoofers

Open Question

Need wiring diagram for alpine tvet720,plug been cut off..arr thanks

Posted by on

2 Suggested Answers

  • 11 Answers

SOURCE: need to know the factory

there should be a red wire and a black wire and a yellow red is hot black is ground and yellow is cons.

Posted on May 03, 2009

kenw392
  • 2226 Answers

SOURCE: i do need Alpine TDM-7526(E)

you can probably get a service manual at pacparts.com.

Posted on Jan 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just bought Alpine car stereo CDE-100EUB but I'm having trouble connecting it to my old car toyota Rav 4 2004 model because the wire harness are different. also the alpine wires are more in numbers than...


Please let me know if you have any questions, and thanks for using FixYa.

2004 Toyota RAV4 Car Stereo Radio Wiring Diagram Alpine wire color
Radio Constant 12V+ Wire: Blue/Yellow yellow
Radio Ignition Switched 12V+ Wire: Gray red
Radio Ground Wire: Brown black
Radio Illumination Dimmer Wire: Green none
Radio Antenna Trigger Wire: N/A blue
Radio Amplifier Trigger Wire: N/A blue/white
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Wire (+): Pink white
Left Front Speaker Wire (-): Purple white/black
Right Front Speaker Wire (+): Light Green gray
Right Front Speaker Wire (-): Blue gray/black
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Wire (+): Black green
Left Rear Speaker Wire (-): Yellow green/black
Right Rear Speaker Wire (+): Red violet
Right Rear Speaker Wire (-): White violet/black

Jan 02, 2011 | Alpine Car Speakers & Subwoofers

1 Answer

How should I wire a 4 channel amp for alpine sps 600, 609


they are only 4 ohm speakers so just put the front speakers on channels 1&2 or a&b and the rear on 3&4 or c&d since you are using a 4 channel amp thats what they are designed for

Jul 09, 2010 | Alpine SPS-600C Car Component System

1 Answer

I need a audio wiring diagram from a 99 nissan frontier


instead of cutting wire by the wiring harness and you will be able to hook it easier

Feb 08, 2010 | Alpine Car Speakers & Subwoofers

1 Answer

I need the wiring dia. for alpine 8020


If the alpine 8020 is a deck(head unit) the wire diagram is as followed:

Red: Accessory
Yellow: Constant Power
Black: Ground
Orange to orange/white is a illumination or dimmer wire.
White: front left speakers
Grey: front left (white black and so on usually the negative on the speaker connections)
Purple rear left (purple black = neg)
Green: Rear Right
And if a video deck(light green is park brake)
(which is usually just a ground) so legally it needs to be on your park brake but can be grounded to make it work.

Speakers? (Terminals larger one is positive, smaller one is negative) Place capacitors on if needed to filter out and clear up bass

Hope this helps couldn't look uo what a alpine 8020 was..

Dec 10, 2009 | Alpine Car Speakers & Subwoofers

2 Answers

Looking for a wiring diagram for a delphi radio that was in a Kenworth semi. I am replacing it with an alpine deck


Often you can go on-line and search by model / year for vehicle wiring, which will save you a lot of time...so, either find the wiring diagram for the vehicle or you need to get your voltmeter out and test the leads for proper power and speaker connections. You need to know the constant 12v + first, isolate it so it doesn't short, then the keyed or accessory 12v +. Then the ground - etc.

Sep 27, 2009 | Car Speakers & Subwoofers

1 Answer

Speakers quit


check ur wires and make sure ur ground is good.be sure u have the neg. and pos. rite all threw the car

Jun 18, 2009 | Alpine Type-R SPR-69LP Coaxial Car Speaker

1 Answer

Sub cutting out


500W x 1 @ 2ohm

How did you "switch the sub from 2ohms to 4 ohms"?

If you have the swr-1222d as listed, your only options are wiring 1 or 4 ohm, as it is a dual 2 ohm voicecoil.

If it was wired @ 1 ohm - you may have already done the damage to your amplifier - as it is not rated @ 1ohm mono.

There are 3 reasons the amplifier will go into protect mode while playing...
Thermal - overheating due to too low impedence.
Ground Loop/Short Circuit - Blown voicecoil, bad amplifier ground, tinsel slap, etc.
Overload - Impedence not within specs.

Disconnect every wire (including RCAs) from the amplifier. Reconnect only power and ground - make a short wire to loop from power terminal to remote terminal.

If the amplifier stays on without turning off - remove the jumper, add the remote wire, and try again.

If it turns off - the problem is internal and needs repair.

Still on? plug in 1 rca, and re-try.... then the other.

Still going??

Now use an Ohm Meter - or Digital multimeter set to ohms 20, and check both voicecoils. They should read 2ohms +/- .5ohm.

If they are OK, wire up the 4ohm load (series the voicecoils) and turn the gain on the amplifier to 1/2.

Retry -

If the amplifier continues to fail at higher volumes - the thermal protection relay has become weakened because of your improper wiring, and will need to be repaired to solve your issue.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Jun 10, 2009 | Alpine Type-R SWR-1222D Car Subwoofer

1 Answer

Bostom tweeter cutting out


get a new tweeter. really, if its starting to cut out, or static, then its prabably old and need a new 1
hope i was help :)

Apr 28, 2009 | Car Speakers & Subwoofers

1 Answer

My Alpine CDA-7863 does not read when I turn the ignition on,the screen does not read,it just make a clicking noise.I have no idea how to manually wire it .I just bought a 1996 tahoe and this Alpine was in...


1. you can go here and get a wiring manual with right model #.
http://www.alpine-usa.com/US-en/support/
2. The red wire goes to ignition switch/key.
Yellow wire goes to constant hot/battery.
Black wire is ground.
Blue wire is for power antana you do not need to hook that to anything.
You can look at this diagram for a little more help it is not your radio though but it will give you a reference point to look at. All radio red,yellow,blue,black wires are the same on all radios.
http://vault.alpine-usa.com/products/documents/OM_CDA-9884.PDF
go to page 42 on this site for wire diagram.
Good luck with problem.

Dec 15, 2008 | Car Speakers & Subwoofers

Not finding what you are looking for?
Car Speakers & Subwoofers Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Alpine Car Speakers & Subwoofers Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Iron
Iron

Level 3 Expert

3018 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Are you an Alpine Car Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...