Question about Wharfedale DVD-M3 DVD Player

1 Answer

Dvdr24hd160f sound but no screen

All of a sudden I cannot get anything on my TV, but i can get sound. It has nothing to do with the tv signal as I have used another digibox and it works fine. Has the freeview circuit gone on this unit?

Posted by on

  • rae0 Dec 23, 2008

    Have had my unit less than 24 hours - all was fine once I got pass the setup menu. I tested recording to HDD and transfered to DVD. Played back fine. A very good recording at HQ

    Looking at some menus - including parential level - entered 0000 ( as in manual) to check options - screen flickered and went blank ( blue in my case). Since then - no video via SCART or COMP but sound is fine.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check out the thread at http://www.pcadvisor.co.uk/forums/index.cfm?action=showthread&threadid=311178&forumid=21 sounds like the same problem (pressing the HDMI button in error) the solution is towards the end of the thread.

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Black Screen - No Signal when connect Bluray to TV with HDMI


I just had the same issue and I believe it was because the sound bar was turned off. The solution was turning on all of my connected equipment such as my sound bar, cable box, tv, blu-ray player, and internet router. It stopped "disconnecting" after only 30 secs of being turned on. I think it was because my husband connected it to all those things in some way so the settings are set to work with those pieces of equipment. With one powered off, in my case the sound bar, the signal can't run full circle and reads as if cut off. Please excuse my nontechnical terminology.

Dec 28, 2011 | Philips BDP3000 Blu-Ray Player

1 Answer

Wharfedale DVDR24HD160F NO PICTURE ONLY SOUND


try the scart leed from your tv to your dvd give it a wriggle if not buy a new scart leed

Nov 17, 2011 | DVD & Blu-Ray Players

1 Answer

TV has sound..no picture Philips DPTV335 was working fine and suddenly picture went out. Still has sound but nothing on screen (volume bars, picture)


This is a projection TV. No picture can have a whole host of causes.
When the TV turns on, you can see background dimly but no picture.
Caused by the picture being muted. Perhaps the video signal is too fast - 1080i on a TV that does not support it might cause this.
Menu works but no image.
Definite picture muting. A bad video cable, no video from the device providing the picture. From the tuner, the signal circuit board needs repair.
No background, no image, no menu
This is a loss of high voltage to the picture tubes. If the picture cannot draw up and down or side to side, this will happen. Definite time for a repairman. Can be pricey if certain parts have blown out.
Most likely is a loss of vertical drive. (up and down drawing of the picture)

Mar 21, 2010 | Philips Magnavox MWR10D6 DVD Recorder

1 Answer

Wharfedale DVDR24HD160F No picture on TV and SET UP on display


check the leads our pushed in firmly, then turn the dvd player off leave for 5 - 10 mins turn back on and hopefully setup instructions will be displayed on your tv follow them thro and that should fix your problem :D

Mar 10, 2009 | DVD & Blu-Ray Players

1 Answer

Emerson VCR/DVD player - can't get tv (cable tv) to play anymore


I have the same problem with my Emerson VCR. When the ADD button is flashing, just press the menu button to exit the menu. It will add. That's the only thing I know to do. Sometimes it works, sometimes it doesn't.

Feb 01, 2009 | Emerson EWD2203 DVD Player/VCR

1 Answer

RCA video "outlet" no longer showing lyrics on TV screens


you probably hit the progressive scan button by mistake..goto mentu and turn it off..

Feb 28, 2008 | DVD & Blu-Ray Players

1 Answer

Dvd burner


Can you try just running a/v cable from your tv output to the inputs on the ilo, then whatever you watch on your tv you can record on your dvd burner. My new SDTV doesnt have audio out except Coax so this won't work for me on that tv. Why doesnt the newer tv's have audio AND video outputs???

Oct 30, 2007 | iLO DVD Recorder DVDR05

Not finding what you are looking for?
Wharfedale DVD-M3 DVD Player Logo

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Wharfedale DVD & Blu-Ray Players Experts

Gareth Cockram
Gareth Cockram

Level 3 Expert

657 Answers

Jonathon summesfield

Level 2 Expert

284 Answers

Soulvisitor
Soulvisitor

Level 3 Expert

1113 Answers

Are you a Wharfedale DVD and Blu-Ray Player Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...