Question about Kodak Printers & Copiers

1 Answer

Photos bluish, new carts installed, calibrated, cleaned, no better

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 479 Answers

Just reinstall the printer drivers again its the problem of the printer settings.reinstalling will automatically set new seeings.

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Saying cartridge error when cartridge is inserted correctly


CLEAN JACK OF CART. & THE CARTRIDGE ITSELF & INSTALL YOUR CART. AGAIN
REMEMBER IF YOU USE REFILLED CARTRIDGE IT WILL SHOW ERROR ,SO ITS BETTER TON USE GENUINE HP CART.(ON INSTALLING GENUINE CART. IT WILL ASK FOR ALIGNMENT SO CLICK ALIGN WHEN PROMPTED.)

Feb 12, 2011 | HP Officejet 4355 All-In-One InkJet...

1 Answer

The printer works OK but it prints two lines clearly but every third is feint almost half the writing is ommitted


Set the print quality to normal or best.
Clean the printhead
Run a calibration.
The Kodak EasyShare AiO performs a calibration every time you install or replace a printhead. However, you can run a calibration if you are seeing changes in the image quality. Calibration aligns the printheads and performs a nozzle health check to enable high-quality prints.
1 Load the main tray or photo tray with photo paper.
IMPORTANT: If you don't have any photo paper, you can use plain paper, but photo paper is highly recommended for calibrations.
2 Press and hold Photo and Cancel together to make a calibration print.
3 Follow the instructions on the calibration print to calibrate the printer.

Feb 11, 2011 | Kodak EASYSHARE 5100 All-In-One Printer

1 Answer

Printing works but, paper comes out with faded picture. Ink cart. is new. I have a HP Deskjet D4100series disk???


Sometimes it takes more than a couple tries to get the right settings the first time you put in a new ink cart. Try using the calibration setting for the printer under it's properties?

Mar 15, 2010 | HP Deskjet D4160 InkJet Photo Printer

2 Answers

Canon ip4300; new printhead and PGBK ink cart but it won't print


call ok canon 800 number..their better than India CAll centres.

Dec 03, 2009 | Canon PIXMA iP4300 InkJet Photo Printer

1 Answer

Dell Photo 926 printer keeps saying that it cant align and wont print after installing new cartridges. Says tape is still on there but it isnt.


1. cancel the alignment .
2. try one cart at a time and only make a copy of a test document ...(press "select" if u get cart missing error ) ...only of the carts is causing the error
3. possible u have defect cart ..or the internal sensor could have gone bad (rare scenario )
4. get a replacement carts...

Oct 25, 2009 | Dell 962 Photo All-In-One InkJet Printer

1 Answer

Hp designjet 30n will not print


replace both ink cartridges with NEW GENUINE HP ink carts.

Jan 27, 2009 | HP DesignJet 30n InkJet Photo Printer

1 Answer

New black installed; will not print in black ink. Everything else prints!


hi, it is possible that the black cart was not installed properly. Try reseating the black cart and see if it works. You can also try to calibrate the printer. you can do this by pressing the menu button then go down to calibrate printer. after that it would also help to perform a deep clean which can also be found on that same menu. then try to print. If all these fails, try to call the kodak hotline 800.421.6699

Oct 16, 2008 | Kodak EASYSHARE 5300 All-In-One InkJet...

3 Answers

My Epson RX620 black cart absolutely will not print


This problem with ur printer nocil ,u can't clean this better to call epson service person .But one thing before u call just confirm ur catrige wether original or compatible

Jun 17, 2008 | Epson RX620 All-In-One InkJet Photo...

1 Answer

Kodak 5300 not printing colors


Kodak told me to take the printhead off and reseat it several times, which I did. I then deep cleaned it, calibrated it, and replaced the color cartridge. It didn't solve the problem. Kodak will replace the printhead for free, and after I return the defective one, will send me a free color and black cartridge. Very nice service. I've been very happy with the 5300.

Mar 09, 2008 | Kodak EASYSHARE 5300 All-In-One InkJet...

1 Answer

Color prints too dark


1. Took out the color ink cart and clean the copper contacts of the ink cart with cotton swab, make sure that you do not touch the silver nozzle .
2. Try new ink color ink carts as someime this issue came up when the ink carts are about to finish up.
3. Replace the ink carts and do not us a refill ink.

Dec 26, 2007 | HP OfficeJet D135 All-In-One InkJet...

Not finding what you are looking for?
Printers & Copiers Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kodak Printers & Copiers Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18298 Answers

Michel Smith

Level 3 Expert

1218 Answers

Sajid Najmi
Sajid Najmi

Level 1 Expert

31 Answers

Are you a Kodak Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...