Question about Epson Office Equipment & Supplies

1 Answer

My Epson Stylus Photo R2400 is not working. When I open the lid to change the ink cartridges, the cartridge drive does not move into the open like it used to. Besides that i just can't get it to print, it just did that overnight. Any suggestions?

Posted by on

  • monkeysoda2 Dec 11, 2008

    Thank you Gremlin, this was a very helpful post. I was hoping it was an easy fix because I doubt it id still under warrantee but I have barely used the thing and so sad that it now doesn't work.
    Will look up service agents.


×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 78 Answers

You have a failed main board, I have seen this before and there is nothing you can do. You need to replace themaiin board and have the firmware updated. This should be done by a regestered service agent.
As the unit is a high end a3, it is well worth repairing. The cost for your repair will not even come close to the cost of a replacement unit, and besides that, none of the new units can do any thing better than this one.
If it is still under warranty, you have nothing to worry about. It will be fixed without question.

Gremlin11

Please remember to rate my assistance.

Posted on Dec 11, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Epson R2400 paper and ink lights blinking red. Ink waste pad replaced and counter reset to 0. Lights still blinking red. Close inspection for any loose objects in printer but none found. Please advise....


Try to turn on your printer without the ink cartridges. When the printer starts and ask for the cartridges, put them back in.

(To remove the cartridges turn on the printer, watch the print head carriage move, when it is at the center quickly unplug the power cable, move the carriage by hand to a position where you can remove the cartridges, after removing the cartridges push the carriage to the right where it should be parked.)

Sep 02, 2010 | Epson Stylus Photo R2400 InkJet Printer

1 Answer

The cartradge block is blocked at the right handside most likely due to a faulty cartridge. How can I manually move the block to the left and get the cartridge out??


For a forced cartridge change it will either be a quick press of the ink button or by holding the paper feed button for 10 seconds. Or there may be a an Ink cartridge replacement option the Printing Preferences > Maintenance section of the driver.

Jan 19, 2010 | Epson Stylus Photo R2400 InkJet Printer

5 Answers

How to change the ink of an epson stylus sx215


press the index sheet button and the scan button at the same time, you then get setup menu. use" >" to select "change ink cartidge". the ink cartidge will move to the opening position. lift the grey plastic clip at the back, and it will open towards you. then they just pull out

Jan 07, 2010 | Epson Stylus Multifunction Inkjet Printer/...

2 Answers

Change ink cartridge on epson stylus SX200 -printing head moves from side to side but then parks to the R and I cannot get access to change the cartridges.........


The ink cartridges are all separate so you press the cancel button (with no jobs pending) to bring the cartridge holder in to the right place open the holder remove the cartridge and then replace it, let the printer purge the cartridge then your good to go

Mar 24, 2009 | Epson Stylus Photo R320 InkJet Printer

1 Answer

Epson stylus k3 r2400


Hi Lisa
The R2400 has the choice of two black inks, MK and PK. One is for Matt printing, the other (called photo black) is for gloss.
If the printer has the matt cartridge fitted it only allows suitable options, including paper choice, to be selected. If you change the black cartridge from the MK to the PK one, you should then have the choice of gloss paper.
Rich

Oct 04, 2008 | Epson Stylus Photo R2400 InkJet Printer

Not finding what you are looking for?
Office Equipment & Supplies Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Epson Office Equipment & Supplies Experts

Alun Cox

Level 3 Expert

2678 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18413 Answers

Are you an Epson Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...