Error message inner cover is open canon pixma mp610 printer
Ok, so here I am in the installation process when after about 2 minutes into the alignment process I get the message above. So I did indeed open and close both covers--started all over again, got the same message. Next, I turned the machine off and began again--got the same error message. Next I turned it off and uplugged it, began again, got the same message. The cover fits just fine, there's no obstacles--what gives--I sure hope I don't have a lemon...It's identical to the one posted bu jude0892
An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert that has over 500 points.
Re: error message inner cover is open canon pixma mp610...
The error comes up when you have the CD tray in it's open position. If it is actually closed then you may have a hardware problem with the printer. If it's under warranty then get it repaired - if not then it's probably cheaper to replace it.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hello sir;Lift up the inner cover , on the right hand side there have a round hole look down the hole you will find a piece metal, try find some stick to push down that's door switch, if the message disapear, means door switch is OK, then have make sure your reset procedure is correct, close all cover turn switch off , UNPLUG power cord, wait for about one minute plug in and turn on the power again, it should be work.
The inner cover is a flap on the inside in front of the carriage when it is at rest when the cover us open. You had to flip the inner cover down to access the ink cartridges.
Open the cover. The inner cover is in the center and need to be flipped up.
Hi there. There have been hundreds of complaints about this problem. You can download a driver AND a user manual from the first link listed below. The second link will take you to a really great site for your printer.
hello, please turn off the printer and turn it on again. If this doesn't help, check that the inner cover is fully opened, and that nothing holds it. If the same problem persists, you should take it to a repair center.
Had the same problem myself but discovered that I had previously moved the inside flap down when I put the ink in. I moved this back into position and bingo! (If you make sure all the covers are closed then look into the printer where the paper exits you will see the flap that moves up and down, this must be in the up position)
On my MP610, you have to look inside from the front of the printer to see the inner cover. It's a cover you have to open to install ink cartridges. It took me a while to figure it out on my printer too. They'd save a lot of headaches by putting a small identifying label on the inner cover.