IR3170CI got problems with error e014

Is the problem interrmittant or comes up every time when you turn the copier on?

You'll need to remove the fuser from the copier and inspect it to see if it is binding up making it difficult for the fuser drive motor to turn it. Lubricate any gears thet are gummed up and not turning well. Pay special attention to the swing plate assy. Also check for frozen bearings,flat spots on lower fuser roller, or anything else that can restrict fuser movement.

If that doesn't fix it - you may need a new motor - but that is almost never the case.


Reference:
http://www.copytechnet.com/forums/canon/41082-cannon-error-code-e014.html

your fixing motor has faulty rotation.
check main motor M2 , DC Controller PCB and image processor pcb

This error usually indicates that the fuser drive motor cannot drive, or rotate properly. It could be a seized fuser assembly, (aka Fixing unit), broken drive mechanism, faulty DC Controller PCB.
It can also be caused by unstable rotation of the fixing assembly, or main motor.

is there an error code appear on panel display?
if there a error appear try to reset you may press * key,press 2&8 simultaneously, the select copier then select fuction then clear then error then ok then turn off& on

The E 805 refers to a locked up fan motor, and the e014 is for the fuser (the part that get hot) not turning correctly. both of these problems require a technician to fix.

I THINK E014 IS FUSER UNIT MOTOR.REPLACE MOTOR.DO NOT FORGET TO RATE SOLUTION.BY MIAN JEE

when I start my machine the error code e014 appears and machine do not run.

k these are notorius for having bad upper rollers if they sit for a long time if you turn the green knob on the fuser and feel hesitation or its hard to move then easy.. or if it sounds like a washing machine at warm up you need a new fuser even if youswapped it the one you put in if not new may be bad

E-014 - The fixing motor has a problem. This can be the fuser drive motor, DC Controller, or Image Processor circuit boards. The only time I've had this problem is with one of the fuser bearing going bad and causing excess drag to the motor, giving you the error. See if the green fuser advance knob is hard to turn. If so then check the bearings.

E806 - This is not in the book that I have. Be sure of the number.

E-805 - There is a fault with fuser cooling fans ( located on the delivery door )

Hi,

Change your DC Motor for the E014,

Samir,