a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Technician (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Code "Q" will increase the impression the space lights indicate i, 2 or three. a little WD 40 on the print solenoid may help. But I believe tour loss of impression is a cracked plastic print solenoid cap. We sell them for 20.00 including shipping and instructions.
first of all check out replacing the ribbon cartridge.if the cartridge is got torn or over stretched.so replace the ribbon .
There is a solenoid down to the left of the horseshoe shaped printwheel mount. If it is gummed up or the nylon hammer plate is broken or missing the hammer will not strike the printwheel and you will not get print out or broken letters on print. Check the solenoid with a thin screwdriver by pulling and pushing the plate and rod in and out as if you were trying to make the solenoid push the hammer toward the type wheel. If the hammer moves when you bush the solenoid then it may be gummed up or not getting electrical impulse. If it moves but the hammer doesn't move then the cushion at the tip of the solenoid is missing and the gap is to great for the solenoid to act upon the hammer. This will help. Thanks please keep updated.please do rate the
solution positively .thank you for using fixya
Is the hammer moving at all? There is a rubber part on the I think left side of the ribbon hammer, down on the side of the printer. This will adjust the amount of impact. I really doubt if
this is the problem, but worth a try to look at. This part and I think it is a blue slide will move up and down to adjust the impact. Possible lubrication and there is a large spring that actually pulls that hammer forward, check to see if this spring is OK. Other than that electronic problems such as main board, printer motors, etc. Does hammer move freely by hand? Also mechanical binding in the printer... GOOD LUCK.