- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
That is an indication of regular functionality from device. Red on device is indication of power on cables ready to capture prints. Usually with devices that has several lightening indication displays, a yellow would be ready to produce print request where finally green is indication that print asignment has been attained succesfully. once a new ink was installed, attempt to print documents to ascertain the status to devcies.
zark4, The green light flashing means you have print jobs waiting to be printed. Don't Turn Off The Printer When The Green Light Is Flashing ! If you have paper in the printer, the red light means you have an empty ink cartridge. Because both things are happening at the same time, here's what you need to do. First click start. Click printers and faxes. Double left click the Epson C-60 Icon. Left click Printer and click Cancel all documents and click yes, then exit. Remove and reinsert your new ink cartridges to make sure they are seated correctly. After you have done this and the printer finishes the automatic charging of the ink cartridges, the lights should be back to normal. Green light on.
You need to contact Xerox on this one. The LCD readout being blank and the machine not responding is indicative of an internal board failure. The red light being on all of the time is an indication of a fault. Without a front panel readout of the fault you will only continue to guess what the problem is.
Definately contact Xerox about your problem or get in contact with a Xerox certified technician in your area.
it's show u a red/orange light blink it's show u hae a refield cartig insarted u need to press red light buttons for 5sec. and then light blink off and only green light only show now give pring if again orange light blink press 5sec. don't give any kind of link on show messages in windows it's gone automaticaly if u have any quary please tell me...
I had the same problem with mine when I bought it. The print head is in the ink cartrige not the printer. If it prints all red, blue or yello one of them is stuck, this happened on the trial cartrige that came with it. I put a fresh 110 in it and it aligned and I have printed a TON of pix with no problems.
If both lights are flashing, it means the Waste Ink Pads in your printer are saturated with ink and the waste ink ("protection") counter has exceeded its limit. The Waste Ink Pads should be replaced (see later). You can overcome this problem temporarily by using the SSC utility - download from
and reset the Protection Counter. This will stop the lights flashing and restore normal operation.
However, remember that eventually ink will overflow from the waste ink area and make a dreadful mess, so you must change the waste ink pads before this happens. This requires the disassembly of the printer. A copy of the service manual is available from a number of sellers - just Google "Epson C62 Service Manual". You will often find them for sale very cheaply on E-Bay.
If you decide to have a go at replacing the ink pads yourself, report back and I will provide further help.
Assume all the ink cartridges are original because a fake one may give that type of warning. I would open the printer and check that the plastic sheet covering the cartridge opening has been taken away. I would take out each cartridge and put it back. If the problem persists, it is likely that the ink in the tank had been dried out (very old stock) or the printer ink sensor is busted. It should still be under warranty I hope.