Question about Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

2 Answers

Wet dishes I have a Whirlpool gold quiet partner IV and it isnt drting the dishes at all. I tried jet dry, increased the water temp and am ready to send it to the landfill. Has anyone else had a similar problem?

Posted by on

  • Anonymous Dec 22, 2008

    It tyrned out to be the heating element

  • Anonymous Jan 03, 2009

    I have the same problem with the dishes not drying well, but the GU1500 does NOT have a dry signal light, so how do I know if it is supposed to heat dry or not?? The only lights on my GU1500 are soaking, water heating, clean and sanitized. The other models (i.e. Gu1100, GU1108, GU1200, Gu2300, GU640, DUL300) ALL have a drying light. So, is the gu1500 supposed to heat dry?? If not, what is the heating element for?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a whirlpool Gold Quiet Partner Gold and when I turn on to wash, the timer says 81 minutes, it runs for a long time and goes to 71 min and runs and runs and runs. It will go down to 47 min and again will run and run. It doesn't seem to get hot like it used to and dishes are wet when all done.(It can run for hours) Thanks

Posted on Apr 05, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 750 Answers

Hello
The heat dry button must be lit up or you are using air dry instead!


ican
Please leave a rating before you leave

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Quiet partner whirlpool III gold reset


TRY A RESET CODE
Press the "Sani Rinse," "Heated Dry," "Sani Rinse" and "Heated Dry" buttons on the dishwasher's electronic control panel in quick succession to put the appliance in diagnostic mode.
Close the dishwasher door and engage the door latch.
Wait 10 seconds before pressing the "Cancel" button to reset the dishwasher.

Dec 18, 2013 | Whirlpool Gold Dishwasher with Quiet...

1 Answer

My whirlpool Gold Quiet partner III won't wash. Dishes come out greasy.


Add Jet Dry and run a cycle with dishwasher empty with bleach and should start working good

Nov 19, 2010 | Whirlpool Dishwashers

1 Answer

How do i check for gloggged jets


clean filters,then run a wash tablet through machine without a load.adrian,,,,

Jul 15, 2010 | Whirlpool 24 in. GU2500 XTP Built-in...

1 Answer

Our quiet partner iii dishwasher is not working. It is not gettting dishes cleaned soap left on dishes


Our whirlpool gold quiet partner iii dishwasher is not working well . It is not gettting dishes cleaned soap left on dishes on top primarily

May 16, 2010 | Dishwashers

1 Answer

The dishes coming out dirty on my Whirlpool Gold Quiet Partner IV. Cycle seems to complete. The soap is being used. Not sure how old it is ... it came with a house I just bought. Any suggestions?


Clean the jets on the unit. Jets are the small openings the water comes out of. Contact Whirlpool, follow their recomondations, or add some CLR or Lime Away to the washer without a load of dishes. Both products remove Calcium Lime and Rust deposits which impede the flow of water, causing your dishes to come out dirty

May 16, 2010 | Dishwashers

1 Answer

My Whirlpool Gold, Quiet model III is not rinsing or drying well. My dishes don't seem clean and there is always diswhashing liquid still in the distribution cup.


the problem that you have is with your water temp not being right to break down the soap and clean your dishes. also you have to fill completely jet dry compartment,very very important for cleaning,drying,and the spots. turn your water on and let it get hot b4 you start the unit . once the water is hot then start the machine. you will see a big difference. send me a 4 thumbs up post if it works

Feb 27, 2010 | Dishwashers

1 Answer

Seem like its not draining. soapy water when finished cycle.


found a kink in the drain hose, shortened hose-problem solved.

Mar 22, 2009 | Dishwashers

1 Answer

WHIRLPOOL QUIET PARTNER IV


Ok this can mean 2 things.
Pump or filter is clogged
or heater is not working correctly. Can you give the precise model number?

Aug 09, 2008 | Whirlpool GU2400XTP Built-in Dishwasher

Not finding what you are looking for?
Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher Logo

683 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

Are you a Whirlpool Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...