Question about Philips Magnavox MWR20V6 DVD Recorder/VCR

1 Answer

My dvd disc tray spins very fast and sound like a car engine.

First the picture froze and then the disc started spinning very fast. No picture just noise. It is a old dvd.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My solution will probably be to throw it out and buy a new one.

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Detrola cd player spins too fast


Did you undo any leads when you changed the belt, are they in the correct position, it's spinning fast because it can't focus.

Aug 29, 2014 | DVD & Blu-Ray Players

1 Answer

Panasonic DMRES15 DVD Recorder disc not spinning


Troubleshooting Solution




1.Display Message " Please wait" Not
booted
2.DVD-Rom Two-Three times make noise but doesnt spinning
3. Doesn't
open tray, No video OUT



1.Bad Main Board VEP79117
2. Bad DVDROM

3. Bad Prosessor
PCB

Mar 16, 2013 | Panasonic DMRES15 DVD Recorder

1 Answer

Dvd player not reading new DVD


probably needs a new belt they do wear out and loosen up over time

Feb 16, 2010 | Philips DVP1013/37 DVD Player

1 Answer

DVD spinning slow and get a 'No Disc' message


Hello,
The problem sounds like the spindle motor is about to go out completely. If a disc does not spin or does not spin at it's proper speed the optical lens reading laser can not read the disc and you get a "no disc", or "disc not recognized" error message. On average a dvd will spin 3 times faster than a regular cd will. The following pictures will show you what these components look like.
179ae67.jpg

163da75.jpg

Check around your local area to find what a service technician will charge to replace the part. On average it will usually cost between $60-90 dollars most of which is labor.

I hope this gives you some idea of what the problem is and how to solve it.

If you would not mind, please rate my help. I would greatly appreciate it. Thank you

Feb 07, 2010 | DVD & Blu-Ray Players

1 Answer

Had one for years but now it does not even want to spin a disc the disc loads ok but jirks not spins and then the display says :-NG DISC?


This will require a good clean on the inside, POWER OFF then remove the cover clean the plastic rack with rubbing alcohol and cotton bud.

If the DVD won't spin due to trapping inside the tray you will never be able to read the DVD check to see if the tray will insert and eject usinf the button,

NOTE : never push the tray to close this can cause the tray to jump its guide dogs leg which is used to lift he head to the DVD after it has been inserted.

Dec 08, 2009 | Sony DVP-F21 DVD Player

1 Answer

Disc spins but no picture or sound


I bought a new one. Thanks anyway.

Nov 02, 2009 | Onkyo DV-S535 DVD Player

1 Answer

Memorex dvd player 2040..disc won't stop spinning!


This is due to faulty DVD lens/head. Try cleaning it with DVD/CD hed cleaning CDs.If still the problem persists, contact near by service center for replacing the faulty Lens.

Mar 13, 2009 | DVD & Blu-Ray Players

1 Answer

Panisonic DVD RV-31 Wont read any DVD...shows a "Ho2" code


The motor is on its way out - the H02 code indicates motor failure as in it cannot spin the disc. You can sometimes fix it but for how long is anyone's guess. Disconnect from the power, remove the three rear screws and two screws on each side (total 7) and lift off the outer cover. Now if you carefully reconnect the power BE VERY CAREFUL NOT TO TOUCH ANY PARTS INSIDE THE CASE and put a DVD disc in as per normal, you'll will see that when the tray closes, the upper platen (a honeycomb disc) that sandwiches the DVD to the lower platen does not spin - it should. Give a gentle spin clockwise and it should spin up and the DVD will play. You may need to restart if you missed your chance first time. If you switch off and on, eject and close the tray, the spin should happen as normal. If it doesn't, your motor is knackered and not an economical repair. Buy a new player. If it spins time and time again, you may well have temporarily fixed it for a while.

Jan 10, 2009 | Panasonic DVD-RV31 DVD Player

2 Answers

DVD stopped playing all DVDs


Reset you player by doing the following:
With the player on, hooked properly to your television, and on the correct station:
Open the tray
Close the tray (with no DVD inserted)
Hold the stop button down for a full 5 seconds
The CyberHome screen should appear. You should be able to play your dvd's now.

Feb 20, 2008 | Cyberhome CH-DVD 300 DVD Player

Not finding what you are looking for?
Philips Magnavox MWR20V6 DVD Recorder/VCR Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips DVD & Blu-Ray Players Experts

Steven

Level 1 Expert

6 Answers

Cindy Wells

Level 3 Expert

4758 Answers

rugby prop

Level 3 Expert

446 Answers

Are you a Philips DVD and Blu-Ray Player Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...