Question about Zebra LP 2844 Thermal Printer
Bit of a tough one to know where to start "Printer is not Running"
They usually sit on a bench and do not run anywhere :-)
Is your power supply plugged in?
Is there a green light on the power Supply?
Is the printer turned on?
Does the green feed button cause a label to eject?
If yes to all the above then try a reset
1) Turn printer off.
2) Hold down feed button whilst turning printer on.
3) Let go of the feed button as soon as it starts to flash and then wait.
4) Printer will measure out 4 labels then print out a Hex dump ending with a not to "Push Feed to Exit"
5) Push feed
Follow the above instructions, if you mess around tapping the feed button (not following the above) you can change the printer between line mode and page mode. To swap that back is another storey.
Posted on Jan 29, 2009
Tips for a great answer:
Aug 24, 2010 | Zebra TLP 2844-Z Thermal Label Printer
Mar 19, 2010 | Zebra LP 2844 Thermal Printer
Mar 10, 2010 | Zebra LP 2844 Thermal Printer
Jan 15, 2010 | Zebra Eltron LP 2824 Thermal Printer
Dec 08, 2009 | Zebra LP 2844 Thermal Printer
Nov 24, 2009 | Zebra LP 2844 Thermal Printer
Jun 17, 2009 | Zebra LP 2844 Thermal Printer
Mar 31, 2009 | Zebra 2746e Thermal Printer
Feb 21, 2008 | Zebra LP 2844 Thermal Printer
296 people viewed this question
Usually answered in minutes!