I have a aiwa video cassette recorder model type hv-50gpsh i cannot tune it to tv channels what is the correct way i have tune it to a tv channel and i am getting the correct signal but canot get the tv channels
An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert that has over 500 points.
Re: how to tune to tv channels
There is a switch [tv-vcr] somewere in the front.When pressed to tv, you can change the channels FROM the vcr.You will need an "air wave" ANTENNA signal because the cable box individual channels cannot be seen when you place the switch to tv.Now if you have a cable box connected properly and turn that tv-vcr switch to vcr the individual CABLE BOX CHANNELS will show through the vcr.
p.s. There is a small switch (someware in the back of the vcr & the back of the cable box,dish box, etc., etc.) ch.3 or ch.4 and the VCR have to be on the same INPUT channel as the box.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I have never heard of any mechanism on a video recorder that would cause the video to eject when a cover is removed. The only thing that might cause it would either be a fault, or something to do with the front facia panel engaging the eject switch when being disassembled.
Check that the scart cable (if there is such that you used) are operating properly and that there is no gap in it. Try switching cables and see if it works better. Check that no parts of the wire stuck in the input / output of the TV or VCR. //David
Your VCR has input to record video-audio signal. Here is 2 options to record program in vcr.
1= You need to hook up video-audio cable at Monitor Out in TV and video-audio in at VCR. select Line-1 or Line-2 (where you hook up cable) in vcr and insert cassette with Record Tab intact, VCR is ready to record TV program. select desired channel on tv and hit record button of vcr, recording will start.
2= Plug RF antenna / cable wire in RF In of vcr and tune desired channel in vcr (get help of vcr's user manual for that) and push record button to start record directly in vcr.
Have further query, let me know please.
Just the usual problem of needing the rubber belts replaced.
Take the top cover off and watch the mechanism move, usually you can
see what the problem is if you get to know its motion. Best
if you learn this before it develops a problem of course.
Buy a kit of belts for your model from all kinds of sites on the net
and install them yourself if you are handy with delicate mechanisms.