Fresh out of the box, I powered it up as it instructed, initially it didn't do anything, then got a 12 on the front panel, finally the door opened, inserted a CD properly, it rotated around as if it were going to play the CD. Now the CD is not in slot one, but in another slot and the machine won't do anything, also got a 11 on the front panel....any ideas or do I have to call JVC.
I had the same problem - I sent the piece of junk back. In the manual, it tells you to disconnect and reconnect the AC power cord - that didn't work and after writing JVC, I didn't hear back, so the unit goes back. What a piece of crap.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Possible that the suspect could be the controller board, you can switch the machine off power for sometime, check the power outlet for the correct voltage. If not the front panel must be removed to check on the board and a possible fault of the processor or memory.
Hello Bobby You haven't given enough details about the fault to your Combo. What do you mean my 'power button has coninuity on board'. I assumes that you get power LED at the front of your device lights up when you switch ON the main power switch, and the unit refuses to power ON and work further. If so, just make a factory reset to this set as it will reset the memory IC. To reset the unit to its factory reset do the folloing. But to do this, the power LED on the front panel of the unit should light up. Otherwise, the fault will be to its power regulator section. To reset the unit to factory reset:  Turn the Power ON.  Hold down both PLAY/REPET and FF on the unit more than 5 seconds. The power will shut OFF. Please ignore "NO CASETTE" warning.  Perform initial set up refering to its user manual. You can see instructions to initial setup at page  of the user manual to your device. OK.
does the power light flash three times slowly then stay off? If so chances are its just the CP150, cp120 and CP114 capacitors. There is the RCA repair kit by that same name available from www.tvrepairworld.com which has the capacitors and the CD with repair instructions
Honda XL 125R Paris Dakar
Air cooled, four stroke, single cylinder, OHC, 2 valves per cylinder
Bore x Stroke
56.5 x 49.5 mm
Ignition / Starting
CDI / kick
12 hp 8.7 kW @ 9000 rpm
10 Nm @ 8000 rpm
Transmission / Drive
6 Speed / chain
Initially, would suggest checking for a blown fuse at the rear or inside the Sky box. Your description of "no power whatsoever" indicates that the mains is not reaching the internal power supply/regulator of the box. Of course, it would also help to try the unit in another outlet.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.