Question about Delta 2402 Classic Single Handle Kitchen Faucet with Side Spray Chrome...

1 Answer

Sprayer loosing presure

My sprayer looses presure within seconds of using it (left - right) hot, cold, knobs. center faucet, sprayer far right (maybe Delta)

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 33 Answers

If you have a Delta faucet your diverter may need to be replaced. The diveter is located under the spout (see diagram)

sprayer loosing presure - 3cafbb5.jpg

Here are the instructions:

  1. Turn off water to faucet.
  2. Remove handle.
  3. Remove top cap.
  4. Turning spout back and forth gently lift and remove.
  5. Remove and replace diverter.
Hope this helps and please remember to rate this!

Posted on Dec 09, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sprayer hose leaks at the base of the faucet after sprayer replacement and thread tape application


Make sure the internal washer is intact and there is no damage to the parts that you are connecting together. Also, do not use too much tape....one or two winds is enough and wind in in the direction of the action of the female connector (clockwise) so you don't bunch it up in one spot.

May 05, 2012 | Plumbing

1 Answer

New kitchen faucet installed just a trikle of water comes out hot & cold, sprayer is fine


remove the fitting at the end of the faucet, it just unscrews off the end,, when you replaced this, and had the water off, many times the rust in the pipes will break loose and follow up the faucet , which clogs in the fine screen located in the piece at the end of the spout ,, just clean it out and you should be ok

Sep 26, 2011 | Plumbing

2 Answers

Just had a single handle shower faucet installed in my new walk-out developed basement and it seems there is a control on it I want to remove. I can't get the handle to go beyond mid-point and I want more...


Hi im Rossouw

The rest of ur house water in the showers fine?
If not they must install a prv (Presure reducing velve) on the cold going to the house and geyser befor it t,s of to the house and even if the rest of the house water is fine u must ask ur plumber who intalled it if he took the cold water going to the new shower strait of the mains if so he must corect it by t-ing in at the right cold water supply or put a velve on the cold water to ruduse the cold presure . then u will have more hot presure and that means lovely hot shower

plz vote and rate my advice thanx

Jul 17, 2010 | Delta & Single Handle Shower Faucet

1 Answer

Kitchen sink sprayer leaking. Tried to install a new sprayer; but turn off knobs are seized and could not budge. Turned water supply to whole house off, but still cannot remove the old sprayer. These are...


First porblems first; go to Home Depot and pick up two Gator Bite valves (no pipe sweating...work great!), appropriately sized and replace hot/cold water valves under the sink. It would also be best to get 1/4 turn valves instead of a gate valve.

The spray hose is connected at the base of the faucet itself - in the very center of the bottom side of the faucet. It's a very tight and difficult area to work in - you should be able to usscrew the old hose and place the new one directly where the old one was removed.

HTH,
Mike...

Nov 25, 2009 | Hammering

2 Answers

My Kohler Fairfax faucet pressure /flow has dropped (cold)


Verify the cold water outlet has equal pressure as the hot side outlet at the wall. Check the inlet screen on the cold side water line where it attatches to cold water pipe. The screen could be plugged. Then check the cold side hose for any restrictions. Also check if there is a screen on the outlet side of the cold water hose and see if it is plugged. Otherwise the faucet valve is mis-aligned and will need to be rotated and re-tightened to align the valve to the center so both sides have equal water flow.

Nov 08, 2009 | Kohler K-12176-PB Fairfax Single Handle...

1 Answer

Installed brand new marielle kitchen faucet with matching srpay and soap... sprayer is not working. please help


If you used the teflon tape to seal the threads on the sprayer connection. Make sure the tape is has not blocked the line.
Check for any kinks in the hose and it is not pinned against something.

Turn on the cold water and hold the sprayer over the sink and activate.
If nothing happens while still holding the sprayer move from cold water to hot. If still no water there maybe something in the line preventing the sprayer from receiving water.

Highly doubt there is anything mechanically wrong but it has happened before. See if you can swap it for a new one.

Good luck!

Oct 06, 2009 | Price Pfister Marielle Kitchen Faucet with...

1 Answer

No water pressure from Grohe faucet when changed the sink


No, being reversed wouldn't cause it. The only thing that would happen is the direction you turn your handle to get the desired temp. When you remove fittings from plumbing supplies, you can break loose deposits that can clog the faucet. If both the hot and the cold water is affected, then remove the arriator and rinse it clean. That is the little filter looking devise at the end of the spout. But if only one of the supplies are affected (hot or cold) then something has broken loose and is stuck within the valve and needs to be cleaned out. You should take the arriator apart piece by piece making sure to note the order in which you take it apart so it's put back in the right order.

Mar 22, 2009 | Grohe Plumbing

3 Answers

No water flow in kitchen sink


Sorry to say, you will need to replace that faucet, and also when you are shopping for a replacement, inquire about a rosette to cover the hole left by the voided sprayer.
Good luck... 


Feb 24, 2009 | Home

1 Answer

Faucet running in off position


the fixture is set up so off is full to right as you go to the left the cycle is cold then hot if you don't understand turn tap all the way to right and turn on main if you need more help please post comment thank you for useing fixya please rate me

Feb 23, 2009 | Plumbing

1 Answer

Kitchen sink only running with the sprayer


It is hard to be certain without knowing the type of faucet, but if you have the type that has a single lever, it could be 2 things I can think of. If you have seperate knobs, I can only think of one. If you have the type with knobs, take the aerator screen off the end of the faucet, The screen may be plugged with saw cuttings of pvc or what ever type of pipe, or even the water saver orifice may be stopped up. If water runs freely with aerator off, you obviously have a problem there.
If you have the lever type, the ball valve can be in backwards, or even a little way off, and the water can not get to the faucet. I am guessing, the whole faucet assembly MAY be in backwards, but that too can usually be fixed by changing the ball around.
Hope this fixes you up!

Dec 21, 2008 | Home

Not finding what you are looking for?
Delta 2402 Classic Single Handle Kitchen Faucet with Side Spray Chrome... Logo

520 people viewed this question

Ask a Question

Usually answered in minutes!

Top Delta Plumbing Experts

Donni Steen

Level 3 Expert

659 Answers

Ed Mac

Level 3 Expert

731 Answers

john h

Level 3 Expert

12650 Answers

Are you a Delta Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...