Question about Husqvarna 23 Hp 48" Deck Yard Tractor

1 Answer

Need schematics on transmission

How do I get the pump out?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 405 Answers

Http://www.usa.husqvarna.com/home.aspx Try this link and I hope it helps! Merry Christmas!

Posted on Dec 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Swisher zt2560 eaton hydro scimatic


You took it apart without taking notes/pictures on what went where?! Mucho intelligente!

You will have to pay for the schematic if you can get one.

Aug 17, 2016 | Swisher Zt2560 Zero Turn Radius 60" Riding...

1 Answer

Husqvarna 4623 zero turn mower will not move


Maintanance - How to purge Hydraulic drive system Published 01/13/2010 11:56 AM ' Updated 06/02/2015 02:52 PM
How do I purge the hydraulic system?
Hydrostatic transmissions use oil, under pressure, to provide movement for the tractor. The fluid is pressurized with a pump inside the transmission. If any air is in the fluid, the pump will try to pressurize air. This condition is known as cavitation, and is detrimental to the pump since it allows the pump top operate dry. When the pump cavitates it is not pressurizing any fluid, so the transmission is not able to provide the movement needed.
If your mower is new, or has been stored for a long period (longer than 2 months) the transmission needs to be purged before use. Also, if you experience loss of drive, or slower response, then the transmission should be purged first.
The following procedure will remove trapped air inside the transmission(s).
IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.
Step 1- Place the rear of the mower safely onto jackstands on a level surface with engine off and parking brake set.

Step 2- Disengage transmission by placing freewheel control, located at the back of the frame, in the freewheeling position.

2a- Mowers with seperate pumps and wheel motors the freewheel is activated by turnign the bypass valves, one on each pump, two full turns.
The oil resevoir needs to be filled to the specifications listed in the owners manual before starting the purge procedure.
Step 3- Sitting in the operators seat(riders), start engine. After the engine is running, move throttle control to slow position. With motion control levers in neutral (N) position, slowly disengage clutch/brake pedal.
Step 4-Move motion control levers to full forward position and hold for five (5) seconds. Move levers to full reverse position and hold for five (5) seconds. Repeat this procedure three (3) times.

NOTE: During this procedure there may be some movement of the drive wheels, but they are not under load. The air is being removed from hydraulic drive system.

Step 5-Move motion control levers to neutral (N) position. Shutoff engine and set parking brake. Check and add oil as needed for units with an oil resevoir.

Step 6-Engage transmission by placing freewheel control into driving position, or by closing the bypass valves on the pumps.
Step 7-Sitting in the operators seat, start engine. After the engine is running, move throttle control to full speed. With motion control levers in neutral (N) position, slowly disengage clutch/brake pedal.

Step 8-Slowly move motion control levers forward, after the tractor moves approximately five (5) feet, slowly move motion control levers to reverse position.
After the mower moves approximately five (5) feet return the motion control levers to the neutral (N) position. Repeat this procedure with the motion control levers three (3) times.

Step 9-Your mower is now purged and now ready for normal operation.For further information or assistance, we recommend contacting your lo

Aug 06, 2016 | Husqvarna Riding Mowers & Garden Tractors

1 Answer

Fuel line schematic model 461707


opposed twin
carb mounted fuel pump... ???
is it a three or four screw pump ???

it's been a while but I think it's a single hose to the pump. the three bolt pump has a pulse hose on the bottom of it...

Apr 27, 2015 | Craftsman 42 in. Deck 19.5hp Lawn Tractor

1 Answer

Schematic on how to repair the hydrostatic


only that goes wrong most is needs a check cleaned out or replace chang oil and filter change hydroststic pump what is yours doing not driving mower

Sep 03, 2014 | Riding Mowers & Garden Tractors

1 Answer

Where can i find the schematics for a john deere 590D excavator hydralics pump


its hard to get maintenace manuals you will have to try john deer online or a dealer may let you look at one

Aug 31, 2014 | Riding Mowers & Garden Tractors

1 Answer

Left turn pump replacement


it is a pump/wheel motor or a unitized transmission.
pump/wheel motor just change the pump but always do a filter/fluid change as well.
unitized transmission replacing the pump is not something recommended because if it's bad then something else is as well

Oct 18, 2013 | Husqvarna Commercial Zero Turn Mower...

1 Answer

Simplicity 5116 engine won't stay running


make sure the solenoid on the bottom of the carb is opening it needs power to operate and they stick closed from bad fuel

May 14, 2012 | Riding Mowers & Garden Tractors

1 Answer

John Deere 5420N. Fuel leaks out of top of fuel pump at the hand primer. Will I need schematics or special tools to install the repair kit myself?


You need to get a new primer pump and they can be replace with no tools,just unscrew the top off the pump by hand and replace it.

Oct 02, 2009 | John Deere 420,1020,2010,2020,2510,2520...

1 Answer

I NEED INJECTOR PUMP SCHEMATIC FOR JD 400 PUMP


I'm getting hydralic fluid in my engine oil. I was told that it's coming from my power steering unit. It's a JD 400 tractor/backhoe. Would this be correct?

Jun 04, 2009 | John Deere 420,1020,2010,2020,2510,2520...

Not finding what you are looking for?
Husqvarna 23 Hp 48" Deck Yard Tractor Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Husqvarna Riding Mowers & Garden Tractors Experts

Phil Walker
Phil Walker

Level 3 Expert

602 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Dwain Pippen

Level 3 Expert

376 Answers

Are you a Husqvarna Riding Mower and Garden Tractor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...