Question about Dacor Preference SGM365SS Gas Cooktop

1 Answer

Pinnacle Raised Vent System #RV36 or RV 46

I cannot get the raised vent to go up or down. I reset the circut breaker off and on and still does not function

Posted by on

  • cpbuxton Feb 18, 2009

    The key pad doesn't work (but lights) and the motor goes on and off periodically. My vent is on the same circuit as the Dacor stove top, so turning the breaker off and on also means no electrical switch to start the gas burner.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Ours started doing the same thing. I got it to start working again by gently holding down the up/down button until it started to move. After doing this a few times it started working normally again. Also the keypad can be locked and unlocked by pressing the low and high buttons together for 1 second.

Posted on Mar 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vent fan only works on low setting


check the bossing or the bearing of the vent put/spray oil or grease on bearing and shaft.....

Dec 09, 2013 | KitchenAid KXU2836YSS 36" slide-out vent...

1 Answer

We have a viking cook top and the vent goes up and down but the fan does not always turn on ? Can you help


Hi,
Some units have a dead man switch, which means that if the filters are not in place correctly the blowers will not operate. Its a safety thing to prevent little ones from dropping toys into a running blower. Double check the filters placement, if the filters are in the proper location than I would look at the power to the blower unit. The vent has two jobs, (1) to raise and lower, (2) to turn on the blower unit once in the full up position. If this is not the case, the upper switch in the vent system has failed. If you already confused, you will need to call a Viking expert to correct this problem. Its not difficult but can be time consuming.
I hope this helps
I have seen this problem twice and found the filters were the problem, rarely replace blower motors..

Jul 26, 2011 | Viking Cooktops

1 Answer

I have a whirlpool gas dryer mod #LGR7620LW0. Some heat, good airflow, is there a cause for low heat?


run with vent off for 1 load and see what the results are, just cause you have airflow does not mean it is sufficient, too long a vent can cause that too. and low heat is almost impossible, check it with a thermometer at the exhaust, no vent connected, it should read 155 to 170, it will go up and down!

Nov 16, 2009 | Cooktops

1 Answer

Hi My extractor hood in the kitchen has a hose that goes into the kitchen roof then out through the roof vents. The problem is that all the cold and wind comes back down the hose and makes the kitchen very...


You need to install a damper. It sounds like your vent now just vents into the attic and out the attic vents. If that is the case, or even if it vents directly to a roof vent, you can install a damper that only lets air flowe one direction.

rewilliams_2068_131005279

springload.gif Here is just one source of many that you can purchse dampers from.
http://www.rewci.com/416splobada.html

The damper would be installed in the exhaust duct. If your vent pipe is connected to a roofmounted vent, you can replace the vent with a dampered vent.

Aug 30, 2009 | Bosch 22 in. PCD685F / PCD685D / PCD682D...

1 Answer

Thermador Cook 'n' Vent Stove with stuck vent (model # SGCS304RS)


I just had a similar problem. The switch knob, and backer for the blower got jambed in the housing. After pulling it all apart I called the parts center at Thermador and ordered a new switch. If you can hear the motor the raises the unit run, then that could be your problem.

Oct 11, 2008 | Cooktops

3 Answers

Downdraft vent on jenn air cooktop


How do you get the inside area of the vent clean from the grease and oils where the filter is?? I have a rectangular box style downdraft that the vent goes into the floor, I pulled the filter, but the box is to slender to get an arm into to scrub the grease....... does the bottom come off, or is it a sealed unit? How do you get all the brease from the bottom if you cannot reach it?

Jul 09, 2008 | Jenn-Air JED8230 Electric Cooktop

1 Answer

Dacor 46 inch 6 burner cooktop


The cost of the parts you want t o replace will usually exceed the price of a new cooktop.

Jun 08, 2008 | Dacor Preference SGM466 Gas Cooktop

1 Answer

Raised vent system won't stay in down position


sounds like yo u have a faulty home switch. when dropped to lowest setting it should switch off electric. however if switch is bad never senses its down adn thenwants to open back up. there should be an acces panel in lower right corner of unit along witha wire diargam

Mar 08, 2008 | Cooktops

Not finding what you are looking for?
Dacor Preference SGM365SS Gas Cooktop Logo

Related Topics:

601 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dacor Cooktops Experts

meztang
meztang

Level 2 Expert

112 Answers

Brad Brown

Level 3 Expert

13732 Answers

Mark Taylor
Mark Taylor

Level 3 Expert

728 Answers

Are you a Dacor Cooktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...