Question about Sony FD Trinitron WEGA KV-32FS120 32" TV

1 Answer

Sony kv32fs13 No Picture or sound stand by light flashing

It was working fine I moved it and now you turn it on and can here the relay pull in and it sounds like its going to come on and nothing.
The stand by light flashes 3x slow then 4x fast and keeps 4x fast over and over.

Posted by on

  • mitch22 Dec 10, 2008

    turns on and then cuts completely back off and the stand by light flashes about 5 or 6 times. A repair guy said i needed a new motherboard, but someone else said the problem is a voltage issue and i need to replace 2 chips that cost about $8.00 a piece vise a motherboard which will run me about $500.00

  • Anonymous Dec 10, 2008

    no picture

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 105 Answers

Try to resolder back the pcb some part is loose connection

Posted on Dec 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My sony kv32hs500 just stoped working and standby light flashing


sir you need to un plug your t.v set and plug it again to reset the memory setting...

Aug 06, 2009 | Sony FD Trinitron WEGA KV-32HS500 32" TV

1 Answer

32 in. Sony Trinitron stand by light keeps flashing


has a sony 41" REAR PROJECTION TV THE STAND BY LAMP IS BLINLING HAS RESET IT , NOTHING. HAS NO PICTURE NO SOUND

Jul 31, 2009 | Sony FD Trinitron WEGA KV-32FS120 32" TV

1 Answer

Sony Model KV32FS13, blinking lights.


check the horizontal output of your tv set,if short you need to replace it.

Dec 09, 2008 | Sony KV-32FS13 TV

1 Answer

Standby/stereo light blinking no picture or sound


My picture would go out after several minutes but I still had sound. I took the rear cover off and blew all the dust off with compresed air.I did this for a few times over several days nothing happened.I also took off the rear circuit board that attaches to the tube with a round pin socket and blew that with compressed air and put it back on. The TV has now worked for two days without the picture going out. It worked!!!!!!!!!!!!!! My TV is 9 years old.

Aug 31, 2008 | Sony KV-36FS100 36" TV

1 Answer

Sony problem


I suspect cold solder joints on mother board and power supply or power supply starting to go . bad driver transistors.


est for tv shop is 160 t0 225


thanks doctor video

Jun 06, 2008 | Sony FD Trinitron WEGA KV-36XBR800 36" TV

1 Answer

No picture on tv but have sound


how many times it flashes?? if its more than 6 times you have a problem. just lick the red wire that goes to the picture tube.if it does not kill you, you are lucky

Jan 07, 2008 | Sony FD Trinitron WEGA KV-32FS120 32" TV

4 Answers

Sony kv32fs16 problem


The STANDBY light is flashing on the television and there is no picture or sound. Solution
sp.gif sp.gif The STANDBY light will flash if an issue is detected within the television. This can sometimes be resolved by simply following the steps below to reset the television.
  1. Turn off the television. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.
  2. Unplug the television power cord from the electrical outlet.
  3. Let the television remain without power for 60 seconds.
  4. Plug the power cord back into the electrical outlet. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
  5. Turn on the television.
If the issue is still unresolved after following all of the troubleshooting steps, service may be required. Please note the number of times the STANDBY light flashes and relay that information to the service center.

Nov 02, 2007 | Sony FD Trinitron WEGA KV-29LS35 29" TV

2 Answers

Sony FAQ Troubleshooter does not help enough


You have a power supply short. Are the tubes lit in back of set? If so you have filament and no high voltage. This could because a Horizontal output, or Vertical output bad. Will need someone who knows about soldering and unsoldering.

Sep 13, 2007 | Sony KV-32FX60 TV

1 Answer

Sony KV-24LS35U green light flashing 11 times


The Sony error codes go up to 7, so when the standby light flashes 11 times it usually means that one of the clock or data lines deep inside the set is shorted to ground. This is not fixable from the front or through the remote, so the set should be serviced by a qualified tech familiar with Sony sets.

Aug 06, 2007 | Sony KV-DR29M69 29" TV

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-32FS120 32" TV Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68157 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Are you a Sony Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...