Question about MSI K9VGM-V Motherboard

1 Answer

Press F1 to resume

When i started my pc it have power and started narmally and gives me this message (not enough space inrun time area.smbios data will not be available.press F1 to resume) and when iam press F1 going vere will pls informe me???

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 63 Answers

Try changing the CMOS battery (leave the battery out for 5mins then replace with new 1) if that does not work flash the BIOS

Let me know how you get on...
Matt

Posted on Dec 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cmos checksum erroe defaults loaded


press del to enter setup.then choose default bios setup. then save and exit.pc will restart.

Nov 17, 2011 | Gigabyte GA-945GCMX-S2 Motherboard

1 Answer

My system only boots as far as the initial bios screen where it says Press F1 or Delete for setup and just hangs there. The keyboard indicators light up, but it will not boot any further.


Good Morning!

and wish you a Happy New Year2011.

1. Visual checkup of the Motherboard: See for any defective capacitors on the board near Processor. A defective capacitor will have a tapered surface and a good one will be flat, on the top. You need to service motherboard. Most of the motherboards carry 3-years warranty.


asian_snake_0.jpg

2. RAM problem: try to put your RAM chips in another slot if vacant. if you have two slots and both are occupied, then try starting system, by placing one RAM at a time and in each slot alternately.
If any combination works then you can make out if and whether your RAM or its slot is faulty.

3. Hanging due to overheating: Before you get the message "Press F1....", pres PAUSE key several times, it should halt the process and the message will not be displayed. This will make sure that the system is halted by pressing the PAUSE Key. After one minute, release pause by pressing any other key and see if you can move further. There may be two possibilities . . .

a) If you are still in the same position, where you have paused the system. The system is halted due to CPU over-heating. Clean the CPU fan with blower or a vacuum cleaner. See, if all of the locks of the CPU FAN and the heat-sink are intact. If the fan itself is not rotating, check for the fan cable and if it is OK, then try replacing CPU Fan.

b) You have reached the same point where it used to stuck before, i.e. at "Press F1...". Now this means your system has halted while detecting other peripherals or add-on cards.

i. HARDDISK: Most possible cause is your HARDDISK is making "click-click" sound and not getting detected. Switch off system and remove all HDD cables (Power and Data both). Start your system and see if you get any message like "insert system disk" this means there is problem with your HARDDISK. the same problem may be caused due to CDROMs. try same and try again.

ii. SMPS POWER SUPPLY: This symptom may be caused due to inadequate power supply. You can change SMPS and make sure if the problem is due to power supply.

iii. ADD-ON CARDS: Remove any add-on card like, Sound card, Graphics card, Modem and switch on the system. if system starts, then turn-off PC. Try placing one card at a time. and start system to make out which card is making the problem.

If the problem remains, get back to us.

Have a nice day!

Jan 03, 2011 | Mercury KVM800M Motherboard

1 Answer

Not enough space in runtime area smbios data will not be available


asus motherboard pc since yesterday when booting at start beeps twice and only after "checking nvram" BIOS shows this message:

Not enough space in Runtime area. Not enough space in Runtime area. SMBIOS data will not be available. SMBIOS data will not be available. Press f1 to resume. Press F1 to continue.
please help boss? ym: siluman_komunikasi@yahoo.co.id

Dec 15, 2010 | ASUS MB M3A32-MVPDELUXE/WIFI RETAIL...

2 Answers

Hi i have a ecs a770m-a m/board inno 8800gts 2gig ocz when i turn on my machine it does the usual boot up then gets to the point were it says cmos battery low press f1 to resume i press f1 the it goes into...


You need to replace the small battery on your motherboard, You can get them at Radio Shack. The battery number is CR2032 it looks about like a quarter. With your computer off, open your computer case find the battery in its holder pop it out and replace it with the new one. Now when you power the system back on go into setup usually by pressing either the "del" key or "F2" key after you go to setup exit the screen by pressing either "esc" or "F10" your system will finish booting and you should be back up and running.

I hope this helps, if so please rate my solution.

Buddy
Corporate Computer
www.ccl-la.com
Over 21 years of PC and printer support/repair

Jun 19, 2009 | EliteGroup MB ECS A770M-A 770 SB600 AM2+...

1 Answer

Asus bios problem


Unless there is a compelling reason to update the bios it should be left alone. Apparently this is one reason for that sage advice.

Go back to asus, download an older version of the bios and install it. Fortunately you didn't end up unable to boot or you would be buying a new board.

Apr 29, 2009 | ASUS MB P5KPL-CM C2D LGA775 INTELG31 ICH7...

2 Answers

Press F1 to resume at start up?


When you go into you setup screen,choose the setting that you want,then tell it to save the settings. If irt is loosing the setting then likely  the cmos battery is bad and needs to be replaced.

Mar 01, 2009 | EliteGroup ECS 945GCT-M/1333 Motherboard -...

1 Answer

What video card to get?


is this for gaming, online gaming or just a necessity? If it's just for replacing a burned-out vid card....I would just get an ATI Rage 128 Ultra, they can be had for very cheap, and are easily available. $5 should be what you pay for one.

Jan 12, 2009 | Intel D915GAG Socket 775 Motherboard -...

1 Answer

Problem after updating asus bios


The first thing I would try is to clear CMOS. Either set the jumper on the motherboard to do this, or even remove the battery, and wait half an hour or so. When installing a new CPU, and even RAM, you should always clear CMOS.

Cheers

Nov 11, 2008 | Motherboards

5 Answers

Not enough space in Runtime area!!


I have the same problem (Not enough space in Runtime area!!) with my new DELL Vastro 220,
what should I do? I baught it yesterday it was expensive

Apr 21, 2008 | ASUS MB M3A32-MVPDELUXE/WIFI RETAIL...

1 Answer

Want bootup says checksum bad


Usually, the message you are seeing is displayed when your CMOS loses power abnormally. Even when your computer is turned off, there should always be a low-level charge from the battery, keeping track of your PC's clock, and storing information about your BIOS settings.

If the CMOS battery is dying, it will produce a weaker charge, or continuously start and stop providing power, which will trigger that message. as a result, you are losing all your BIOS settings that you are configuring each and every time, and getting that message when it happens.

It's odd that you would be getting that message when you replaced the battery, but I'd try replacing it with another one just to be sure. If it doesn't fix the problem, the motherboard may need to be replaced. In this case, the problem could lie with wireing between the casing and the chip, or even be in the chip on the circuit board itself.

You could also try flashing the motherboard, but only use that as a last resort- you could finish toasting it. Also, I can't guarantee it would fix it in the future, as all you're doing is adressing the symptoms, and forgetting about the cause.

Dec 30, 2007 | MSI K8MM-ILSR Motherboard

Not finding what you are looking for?
MSI K9VGM-V Motherboard Logo

Related Topics:

519 people viewed this question

Ask a Question

Usually answered in minutes!

Top MSI Motherboards Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

Mark Taylor
Mark Taylor

Level 3 Expert

728 Answers

Are you a MSI Motherboard Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...