Question about Toys

Open Question

Problem with remote control car

I bought a remote control car with band 27 Mhz (MEIJIAXIN's Ferrari F40). It worked fine on day1 but from day2 it is not working properly....it is working for some time and immediately it stops working, could not able to find what the actual issue.

Posted by on

  • rome151 May 11, 2010

    this is not enough info. what stops working? steering , motor, do you get that jerking of the wheels?

×

5 Suggested Answers

  • 124 Answers

SOURCE: Remote starter stopped working

Will you rate my answer from my clarification as a solution about the antenna thanks Mike humble.

Posted on Dec 15, 2008

bunnydawg
  • 5158 Answers

SOURCE: need frequencies covered by pyramid SWR-14 meter

it appears to be only good for the cb frequencies.... i suspect it would be too unstable for 2 metre usuage

Robert

Please take a moment to rate this solution.. thanks

Posted on Feb 01, 2009

PABLOCSA
  • 1124 Answers

SOURCE: Universal Remote Codes

Try, 0045, 0043, 0845 or 0154, 0156, 0060

Posted on Feb 03, 2009

  • 50 Answers

SOURCE: remote does not work for Sharp lc42d85u

On this unit if you do a fact reset it should fix this problem steps as follows. PS you might need 2 people

1- unplug unit from back of unit
2- on the key pad on the tv hold the input and vol dowm buttons
3- while holding the buttons plug the tv in, keep holding the buttons until the screen comes up.
4- once the screen is up there should be a white K in a blue or green box.
5- next, on the key pad on the tv press the channel and vol down buttons once.
6- a menu should pop up
7- using the sharp remote,locate the directional pad
8- press the down button once should bring you to a 2nd page
9- top should state FACT INIT press the right arrow once to turn on, next a series of back slashes come up.
10- screen goes green and says INIT Successful
11- unplug unit from back of tv wait 10 sec then plug back in. tv should turn on by itself. should be back to as new.


If you get to step 7 and the remote still does not work then you need to replace the ir sensor board (aka) LED unit per Sharp.


if needed here is the orignal part info DUNTKE868FM01 about $12.00+ tax

Posted on Mar 18, 2009

  • 43 Answers

SOURCE: I have a Bose remote control RC18S2-27 that

Check your settings on the receiver , it might be off.

Posted on Aug 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I change the MHz frequency


How to change frequency on RC toy car? - Instructables

www.instructables.com/.../How-to-change-frequency-on-RC...

InstructablesAug 4, 2009 - My friend and I bought 2 rc toys (1:18 scaled Ferrari F1) just for fun, but they work on same frequency (40.685 MHz) so we can't drive at same time. So i need some suggestions on how to change the frequency on one of them. The transmitter have quartz crystal, but receiver have only ...

Modding Fisher-Price 72825 Formel Junior Fernlenkflitzer

www.instructables.com/.../Modding-Fisher-Price-72825-For...

InstructablesI'll show you how to modify a rc toy car to work on a different frequency. ... the method I describe here should work with nearly every rc car. ... if you mean to change thefrequency from lets say 27.005Mhz to 27.415Mhz, it's basically the same.

How to change frequency on RC toys - Instructables


Dec 26, 2015 | Cars & Co Remote Radio Control Street...

1 Answer

Cheats for ferrari trofeo pirelli?


source JCTC1013
Unlockable How to Unlock Ferrari 250 GTO Win Zaffire Trophy Ferrari 250 LM Win Platino Trophy Ferrari 250 Testarosso Win Rubino Trophy Ferrari 348 Challenge Win Monza Race (Italian Challenge) Ferrari 348 TB Finish in at least 3rd place at Misano (Italian Challenge) Ferrari 360 GT Win Topaz Trophy Ferrari 360 Modena Win Perla Trophy Ferrari 365 GTB/4 Comp. Win Obsidian Trophy Ferrari 512 M Complete Arcade mode on Medium Difficulty Ferrari 512 S Win Opale Trophy Ferrari 550 Maranello Win Tourmaline Trophy Ferrari 575 GTC Complete Arcade mode on Easy Difficulty Ferrari 575 M Maranello Win Malachite Trophy Ferrari F333 SP Win Argonto Trophy Ferrari F355 Berlinetta Win Perla Trophy Ferrari F355 Challenge Win Paul Ricard Race (Italian Challenge) Ferrari F40 Win Bronzo Trophy Ferrari F430 GT2 Win Carnelian Trophy Ferrari F50 Win Bronzo Trophy Ferrari FXX Win Oro Trophy Ferrari Maranello GT Win Malachite Trophy

Jul 28, 2014 | Video Game Consoles & Games

1 Answer

How do I increase power output for a cobra 148 gtl the latest Chinese version


best way is to leave the radio in piece and obtain a linear amplifier to do the job a 10 meter ham radio amplifier will do nicely but you must re-tune it for the 27 mhz band 10 meter band is 28 mhz.
RF amps work best using side-band mode.

Oct 14, 2013 | Cobra 148 GTL 120-Channels Base CB Radio

1 Answer

Can the GRECOM PSR255. be used to scan for aircraft /airband frequencies


Your radio is not capable of recieving air band frequencies. It will only receive 4 bands consisting of: 26 - 54 MHz; 68 - 88 MHz; 137 - 174 MHz and 380 - 512 Mhz.

The VHF airband uses the frequencies between 108 (just above commercial FM radio) and 137 MHZ (just below 2 meter Ham radio). Amplitude Modulation ("AM") is the mode that transmissions are made. The lowest 10 MHz of the band, from 108-117.95 MHz, is split into 200 narrow-band channels of 50 kHz. These are reserved for navigational aids such as VOR beacons, and precision approach systems such as ILS localizers

Jan 26, 2013 | Grecom Gre Psr-255 50 Channel Handheld...

1 Answer

Looking to find the frequenecies of the upper and lower channels



  • Hi I can help.
  • For the Grant 40 channel CB there are 40 frequencies I will list below.
  • When you refer to the upper and lower channels for this raidio you must mean USB (Upper Side Band) and LSB (lower side band).
  • This is called single side band modulation which is to say the the carrier is removed from the upper or lower sideband depending on which your pick and the signal goes farther on less power.
  • So the upper and lower side bands are the same frequency just upper side band or lower sideband.
  1. 26.965 MHz 21. 27.215 MHz
  2. 26.975 MHz 22. 27.225 MHz
  3. 26.985 MHz 23. 27.255 MHz
  4. 27.005 MHz 24. 27.235 MHz
  5. 27.015 MHz 25. 27.245 MHz
  6. 27.025 MHz 26. 27.265 MHz
  7. 27.035 MHz 27. 27.275 MHz
  8. 27.055 MHz 28. 27.285 MHz
  9. 27.065 MHz 29. 27.295 MHz
  10. 27.075 MHz 30. 27.305 MHz
  11. 27.085 MHz 31. 27.315 MHz
  12. 27.105 MHz 32. 27.325 MHz
  13. 27.115 MHz 33. 27.335 MHz
  14. 27.125 MHz 34. 27.345 MHz
  15. 27.135 MHz 35. 27.355 MHz
  16. 27.155 MHz 36. 27.365 MHz
  17. 27.165 MHz 37. 27.375 MHz
  18. 27.175 MHz 38. 27.385 MHz
  19. 27.185 MHz 39. 27.395 MHz
  20. 27.205 MHz 40. 27.405 MHz.
  • If you have any comment please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Aug 29, 2011 | Uniden GRANTLT 40-Channels Base CB Radio

1 Answer

I get static so bad that I can't squelch it down enough to get rid of the noise. Traveling out on the highway it usually works ok. But when I enter a town the static gets badusually around power lines. How...


You could install a filter in the line between the antenna and the transciever. I reccommend a high-pass or band-pass filter set for the 27 MHz band to remove any interference at different frequencies. Also, some older TVs can cause interference to CB radios if they are close. If this doesn't work, the radio may be poorly sheilded or your area may have implemented the broadband power line initiative (BPL). This produces a strong buzz of noise that obliterates all weak to moderate radio signals between 2 and 80 MHz (CB being at 27 MHz).

May 21, 2010 | Cobra 19 DX IV CB Radio

1 Answer

What frequency do these run?? am or fm??


CB or citizen's band is in the 27 MHZ band. Its 40 channels long, AM typically, and on some models side band, or SSB.

It is only legal in the US to have a radio that operates in the 27 MHZ band on the designated 40 channels using AM or single side band only.

The MCB-30 is an AM only radio.

Mar 25, 2010 | Maxon MCB-30 40-Channels Base CB Radio

2 Answers

Hi ihave brought helicopter ftw 730 but the remote control was not its own .the helicopter ftw 730 remote control frequency is 40 mhz but the one i have is 27 mhz so how can i make as 40 mhz remote...


Unfortunately you can't. You will need to change the receiver or the transmitter so they are both the same frequency range eg 40mhz or 27mhz. Then you will need to check the crystal is the same frequency for the Transmitter and receiver eg 40.25mhz. NB. you can't put a 27mhz crystal into a 40mhz set or vise versa it won't work.

Aug 21, 2009 | RC Remote Control Rc Mini Helicopter

1 Answer

New 27 MHZ Helicopter Controller won't turn on


I have a 27Mhz helicoper (looks identical to the one on the picture). I tried to fly it for the first time, but I am having problems controlling it. The left radio control lever sends the helicopter upwards, but the right hand control doesn't seem to do anything and that should make it go backwards and forwards. Can anyone help me as well please?

Mar 05, 2009 | Back To Basics Toys R/C Helicopter (27...

Not finding what you are looking for?
Toys Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toys Experts

kakima

Level 3 Expert

102366 Answers

yadayada
yadayada

Level 3 Expert

71525 Answers

ray gallant

Level 3 Expert

41086 Answers

Are you a Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...