Question about Philips Senseo HD7832 Coffee Maker

4 Answers

Lid is stuck shut on my senseo

My senseo coffe maker the lid is stuck shut will not open what do i do

Posted by on

  • whrubesky Jan 21, 2009

    I can't open the lid. The lever works ust fine but the lid doesn't pop open. I put as pressure as I think it can take but no luck!

×

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I just had this same problem. The seal is stuck and might have coffee jammed in it. I unplugged it. Then I pushed down on the lid and pulled up at the same time. It opened for me. I hope this helps.

Posted on Jan 21, 2009

  • bizbox3 Aug 25, 2011

    The small hole in the pod tray is stopped up and causes the unit to vacuum seal. This can happened to me when I got a bag that had a lot of coffee dust. Give it a while (maybe as much as a day) for the vacuum to release some to get the top open. Clean the small whole on the pod tray - I think I used a needle when it happened to me.

  • diane laverick Sep 19, 2013

    mines stuck shut its been 24 hours anyone got anymore ideas

×

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

The Phillips electronics web site says that pod tube is plugged and now a vacuum has been set up preventing you from opening. It says "unplug it; leave it at room temperature for 24 hours or longer and then try to open. It states you may have to apply a lot of force to get it open. Once you get open clean the pod tube regularly to prevent this from happening!!!!!! Only use recommended pods in the coffee maker. Go to

Posted on Jan 22, 2009

  • dave stewart
    dave stewart Jun 07, 2014

    my problem is that the lid wont close, not that it wont open

×

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I had a same problem, but I managed it open without waiting 24 hours by turning and slightly pulling a small plug behind the water tank on the back side. (see the photo attached) I think it will let air goes in and release the vacuum seal. After I could open the lid, I turn the plug back and push it in as it was. Now, my Senseo is running perfectly again.

lid is stuck shut on my senseo - db9cf54d-367a-434a-89ec-b76ab9c46ca6.jpg1eeead16-0ec4-4a1a-91f3-25ee9017a827.jpg

Posted on Nov 24, 2013

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have no solution ive tried everything but nothing is working HELP

Posted on Sep 19, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No water getting to the pod area of my coffe maker


Give more details. Do you hear the pump? What are the light doing? Do you hear water boiling? I can help, but I need more info.

Aug 09, 2014 | Philips Senseo HD-7810 Coffee Maker

1 Answer

Why wont lid on my phillips senseo hd7863 close when the pod is in the holder ?


Maybe you inserted the pod with the wrong side up or you used a 2-cup pod in a single cup holder. If the clamping spring isn't working (the lid feels loose when you try to close it), that spring (that is nothing more than a straight piece of metal wire) needs to be replaced.

Jun 07, 2014 | Philips Senseo HD-7810 Coffee Maker

1 Answer

A pod burst in the bag. I tried to clean the pods off the best I could, but apparently there were a few grains on them. When I pushed the button on the right it came on for a few seconds. The grains...


fill the unit up with a bottle of peroxide and let stand for an hour. It will soften the gronds to a muddy consistancy so it will flow out. Add water and brew in an hour. It will clean out the unit as well like new

Sep 13, 2011 | Philips Senseo HD-7810 Coffee Maker

1 Answer

Accidently left coffee pod in coffee pot while went on vacation now the machine smells really bad . tryed vinegar but nothing seems to help


Try the rinsing procedure that's in the manual, and use citric acid. The parts that usually come into contact with hot water or coffe can also be cleaned in a dish washer.

Sep 01, 2010 | Philips Senseo HD-7810 Coffee Maker

1 Answer

Senseo hd7810, The locking/unlocking latch on the


The product is still in production, so that should not be the problem. Question is whether the handle is a spare part.

G

Mar 02, 2009 | Philips Senseo HD-7810 Coffee Maker

1 Answer

One coffee cup button switch not wotking properly after 6 months


Call senseo at 866-4-736-736 866-4-Senseo and describe the problem.
if you have purchased or received it as a gift less than two years ago they will send a new one FREE.

Jan 24, 2009 | Philips Senseo HD-7810 Coffee Maker

1 Answer

Lid is sealed shut and water is not being drawn from resovoir


it sounds like the pod holder is clogged, it has only one small hole to let out water. open up the machine in the sink as it will spray due to the water pressure. try the other pod holder first. if it works check the other one by holding it up to the light. if it is clogged clean the first one by using a pin to clear the hole.

If no good,
Call senseo at 866-4-736-736 866-4-Senseo and describe the problem.if you have purchased or received it as a gift less than two years ago they will send a new one FREE.

Jan 14, 2009 | Philips Senseo HD-7810 Coffee Maker

1 Answer

I just received my cuisinart coffe maker DCC1200 and I wanted to brew a pot of coffe but I am unable to open the glass carafe to obtain my coffe filters. Is there a specific way to open this? Your...


Hmm. Better late than never. Just got home with ours. Same problem. Called Cuisinart 800 number. Catch is on top of handle. There is a slight lip on each side there. Pop it up with pressure on both sides simultaneously. To replace, line up lid carefully with top of carafe and press firmly until it pops back on.

Jun 23, 2008 | Cuisinart DCC-1200 Coffee Maker

2 Answers

Senseo stuck after using coffee pods that have "milk" built in....5 days later


I had the same problem. I waited for a while as the instruction says but didn't open. But, I got it open!!! by turning and slightly pulling a small plug behind the water tank on the backside. (remove the water tank then you'll see the little plug. see attached photos) I think it will let air in and vacuum seal get released. After it opened, I gently turned the plug back and push it in as it was. Now, it is running perfectly again. I just had a great coffee. :-)
58c3f6de-9c9e-437e-b419-0533bdf0a452.jpg562b78da-5cdf-43fe-afb9-546e2ba78530.jpgb5d600f7-721a-4b74-a954-ef849424bf28.jpg

May 14, 2008 | Philips Senseo HD-7810 Coffee Maker

Not finding what you are looking for?
Philips Senseo HD7832 Coffee Maker Logo

9,106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Coffee Makers & Espresso Machines Experts

Kolbrun...

Level 3 Expert

1194 Answers

Lisa
Lisa

Level 2 Expert

91 Answers

Ross Keen

Level 3 Expert

1189 Answers

Are you a Philips Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...